Filter
Top Products
INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY AND
CAREFULLY. THEY WILL SIMPLIFY THE INSTALLATION.
1. After removing the shipping carton, be sure to remove
all protective packaging materials such as tape and
shipping pads. Put extra key-knob In a safe place
Waxy residue from protective shipping material may
be removed from compactor with a mild solution of
liquid household cleaner and water.
2. Your compactor is designed for recessed installation.
A six (6) inch clearance from the right edge of the
drawer front is desirable for added convenience in bag
removal. Also allow twenty-three (23) Inches in front
of the appliance for drawer removal. See Figure 3.
COMPACTOR
\\I
WALL OR
OTHER
OBJECTS
l&l
=a
u
2-J” ,,
\\
6
FIGURE 3
3. The compactor’s overall dlmenslons are Height 34.
l/16” (min.), Depth 24”. Width 15”. Select a cabinet
opening to fit. See Fi.qure 4.
MIN
FIGURE 4
4. Remove drawer as shown
a
Grip handle and raise front of drawer uri!!! ,I
clears stops See Figure 5
b. Grasp side ridges of !he drawer and lift drawr>r
out See Flgure 6.
\
FIGURE 5 FIGURE 6
5. Remove any materials that are shipped In the drawer
Some models have a literature storage compartment
located inside the front panel. See Figure 9. DO NOT
REMOVE THE BAG.
6.
Lay two carton corner posts or other protective
material (such as a throw rug) on the floor, then lay
the umt on either of Its sides on the corner posts. The
corner posts will protect the finish of the compactor
and the floor See Figure 8. NOTE: Do not truck or
handle by console.
FIGURE 8
Remove the cardboard shipplng pad located on the
bottom See Figure 8 Stand compactor upright
7. A grounded receptacle should be located 18” (mln )
from the floor and in the center of the opening. See
Fioure 9
8.
FIGURE 9
Before moving the compactor Into posItion, measure
the cabinet opening as shown In Figure 70 To
determIne If height adjustmenr
IS
required. see steps
9 and 10 below
-CABINET OPENING
FIGURE 10
9. The rear wheels of your compactor are preset for a
mlnlmgm cabinet opening of 34-l ‘8” to 34-l 14”
(posItIon A) To adjust for higher openings. t:ll the
compactor to one side and support with a corner post
or a screwdrtver handle
CAUTION: Use care so that the compactor does
not drop on your hand.
10.
To adjust the height. remove screw from posltton A”
In Figure 11. Move the rear wheel and screw to
posltlon “B or C”,
34-l/4” to 34.1,*2” use position “B”
34-l/2” to 34.3/4” use posltion “C”
A
w
“,:
FIGURE 11
Repeat for other rear wheel
2