KitchenAid KERC507 Range User Manual


 
9
Coil Elements and
Burner Bowls
(on some models)
Coil elements should be level for optimal cooking results. Burner
bowls, when clean, reflect heat back to the cookware. They also
help catch spills.
Cookware should not extend more than 1 in. (2.5 cm) over the
coil element. If cookware is uneven or too large, it can produce
excess heat causing the burner bowl to change color. For more
information, see the “General Cleaning” section.
Before removing or replacing coil elements and burner bowls,
make sure they are cool and the control knobs are off.
To Remove:
1.
Push in the edge of coil element toward the receptacle. Then
lift it just enough to clear the burner bowl.
2.
Pull the coil element straight away from the receptacle.
3.
Lift out the burner bowl.
To Replace:
1.
Line up openings in the burner bowl with the coil element
receptacle.
2.
Holding the coil element as level as possible, carefully push
coil element terminal into the receptacle.
3.
When the terminal is pushed into the receptacle as far as it
will go, push down the edge of the coil element opposite the
receptacle.
Lift-up Cooktop
(on some models)
The lift-up cooktop provides easy access underneath it for
cleaning. Be careful not to drop it because damage could occur
to the finish and the cooktop frame. For more information, see
the “General Cleaning” section.
To Lift:
1.
Lift the front of the cooktop at both front corners until the
support rods lock into place.
To Replace:
1.
Lift the cooktop from both sides while pressing the support
rods back to unlock them.
2.
Slowly lower the cooktop into place.
WARNING
Explosion Hazard
Do not store flammable materials such as
gasoline near this appliance.
Doing so can result in death, explosion, or fire.