KitchenAid KERS505 Double Oven User Manual


 
12
Oven Lights
While the oven doors are closed, press OVEN LIGHT to turn the
lights on and off. Both oven lights will come on when either door
is open. The oven lights will not come on during the Self-Clean
cycle.
Timer Set/Off
The Timer can be set in minutes and seconds or hours and
minutes and counts down the set time.
NOTE: The Timer does not start or stop the oven.
1. Press TIMER SET/OFF.
2. Press the number pads to enter length of time.
3. Press TIMER SET/OFF to start the timer.
When the set time ends, timer completion tones will sound,
then reminder tones will sound approximately every
60 seconds.
4. Press TIMER SET/OFF anytime to cancel the Timer and/or
stop reminder tones.
If OFF is pressed, the oven will turn off.
The time can be reset during the countdown by repeating the
above steps.
Options
Fahrenheit and Celsius
The temperature is factory preset to Fahrenheit, but can be
changed to Celsius.
1. Press OPTIONS once.
“TEMP UNIT” appears in the upper text area. “FAHRENHEIT.
Press (1) for Celsius” will scroll twice in the lower text area.
2. Press “1” to change the temperature unit setting.
“CELSIUS. Press (1) for Fahrenheit” will scroll twice from right
to left in the lower text area.
3. “CELSIUS Selected” will scroll twice from right to left in the
lower text area. The temperature units have been changed.
Ton e s
Tones are audible signals, indicating the following:
Basic Functions
One tone
Valid pad press
End of Kitchen Timer (long tone)
Function has been entered
Two tones
Oven is preheated
Three tones
Invalid pad press
Four tones
End of cycle
Adjusting Sound On or Off
The oven sound is factory preset for On but can be changed to
Off.
1. Press OPTIONS twice until “SOUND” appears in the upper
text area and “ON. Press (1) for OFF” scrolls twice from right
to left in the lower text area.
2. Press “1” to turn the sound Off. “OFF. Press (1) for ON” will
scroll twice from right to left in the lower text area.
3. “OFF Selected” will scroll twice from right to left in the lower
text area. The sound has now been turned off.
Adjusting Sound Volume
The oven sound is factory preset for High but can be changed to
Low.
1. Press OPTIONS 3 times until “SOUND VOLUME” appears in
the text area and “HIGH. Press (1) for LOW” scrolls twice from
right to left in the lower text area.
2. Press “1” to turn the sound Low. “LOW. Press (1) for HIGH”
scrolls twice from right to left in the lower text area.
3. “Low Selected” scrolls twice from right to left in the lower text
area. The sound volume has now been changed.
Adjusting End Tone On or Off
The end tone is factory preset for On but can be changed to Off.
1. Press OPTIONS four times until “END TONE” appears in the
upper text area and “ON. Press (1) for OFF” scrolls twice from
right to left in the lower text area.
2. Press “1” to turn the end tone Off. “OFF. Press (1) for ON” will
scroll twice in the lower text area.
3. “OFF Selected” will scroll twice from right to left in the lower
text area. The end tone has now been turned off.
Adjusting Keypress Tone On or Off
The keypress tone is factory set for On but can be changed to
Off.
1. Press OPTIONS five times until “KEYPRESS TONE” appears
in the upper text area and “ON. Press (1) for OFF” scrolls
twice from right to left in the lower text area.
2. Press “1” to turn the keypress tone Off. “OFF. Press (1) for
ON” will scroll twice in the lower text area.
3. “OFF Selected” will scroll twice from right to left in the lower
text area. The keypress tone has now been turned off.
Adjusting Reminder Tone On or Off
The reminder tone is factory preset for On but can be changed to
Off.
1. Press OPTIONS six times until “REMINDER TONE” appears
in the upper text area and “ON. Press (1) for OFF” scrolls
twice from right to left in the lower text area.
2. Press “1” to turn the reminder tone Off. “OFF. Press (1) for
ON” will scroll twice in the lower text area.
3. “OFF Selected” will scroll twice from right to left in the lower
text area. The reminder tone has now been turned off.
Clock
The clock can be set to display time in a 12-hour or 24-hour
format. The clock is factory preset for the 12-hour format.
To Change the Clock to 24-Hour Format:
1. Press OPTIONS seven times until “12/24 HOUR” appears in
the upper text area and “12 HR. Press (1) for 24 Hr” scrolls
twice in the lower text area.
2. Press “1” once to select 24 hour and again to select 12 hour.
3. Wait 30 seconds or press OFF to accept the setting.