KitchenAid KUDP01FL Dishwasher User Manual


 
12
A small amount of water is run through the pump to remove
soil particles between the main wash and final rinse.
NOTES:
The sensor in your dishwasher monitors the soil level. Cycle
time and/or water usage can vary from the numbers above as
the sensor adjusts the cycle for the best wash performance.
In the Normal cycle, the dishwasher pauses while soaking.
Soaking helps loosen soils on dishes for brilliant results.
Canceling a Cycle
1.
Carefully open the door slightly to stop the cycle. Wait for the
spraying action to stop before opening the door to access the
control panel.
2.
Press
Cancel glows.
3.
Close the door. The dishwasher starts a 2-minute drain (if
needed). Let the dishwasher drain completely.
To stop the drain
You can press CANCEL again to stop the drain. Remember to
drain the dishwasher before starting a new cycle.
To clear the indicators
Press CANCEL before starting the dishwasher to clear all options
and cycles.
Changing a Cycle or Setting
During the first minute of a cycle
1.
Open the door.
2.
Press a new cycle and/or options.
3.
Check the detergent dispensers. They must be filled properly
for the new cycle.
4.
Close the door. The dishwasher resumes the new cycle
and/or option after a 5-second pause.
After the first minute of a cycle
1.
Carefully open the door slightly to stop the cycle. Wait for the
spraying action to stop before opening the door to access the
control panel.
2.
Press
Cancel glows.
3.
Close the door. Your dishwasher starts a 2-minute drain (if
needed). Let the dishwasher drain completely.
4.
Select a new cycle and/or options.
5.
Press START.
6.
Check the detergent dispensers. They must be filled properly
for the new cycle.
7.
Close the door.
Adding Items During a Cycle
You can add an item anytime before the main wash starts. Open
the door and check the detergent dispenser. If the cover is still
closed, you can add items.
To add items
1.
Carefully open the door slightly to stop the cycle. Wait for the
spraying action to stop before opening the door.
2.
Open the door. If the detergent dispenser cover is still closed,
add the item.
3.
Close the door firmly until it latches. The dishwasher resumes
the cycle after about a 5-second pause.
Option Selections
You can customize your cycles by pressing an option. If you
change your mind, press the option again to turn the option off.
Select a different option if desired.
You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
any time before drying begins.
Press START to repeat the same cycle and options as the
previous wash cycle.
NOTE:
If the last cycle you completed was a rinse cycle, when
you press Start, the dishwasher runs the last full wash cycle and
options.
Use this cycle for pre-
rinsed and lightly-soiled
loads. During the heated
dry, the heating element
cycles on and off.
Use main
detergent
dispenser section.
Soil
Level
Sensed
Rinse Main
Wash
Rinse Purge† Final
Heated
Rinse
Dry Time
(min)
Water
Usage
(gal/L)
Heavy
120°F
(49°C)
135°F
(57°C)
cycled
79* 7.1-8.6/
27-33
Light
120°F
(49°C)
135°F
(57°C)
cycled
71* 5.9/
22.3
Use this rinse cycle for
rinsing dishes, glasses, and
silverware that will not be
washed right away.
Do not use
detergent with this
cycle.
Soil
Level
Sensed
Pre-
Wash
Main
Wash
Rinse Rinse Final
Heated
Rinse
Dry Time
(min)
Water
Usage
(gal/L)
10 1.8/7