Filter
Top Products
13
Hi-Temp Scrub
Select this option to heat the water during parts of the cycle, and
add a rinse. Higher water temperatures and an extra rinse help
clean tough soils. Hi-Temp Scrub, with the Heavy cycle, raises
the water temperature in the prewash and main wash. Hi-Temp
Scrub, with the Normal cycle, raises the water temperature in the
main wash.
This option adds heat, water and wash time to a cycle.
NOTE:
Hi-Temp Scrub is an option with the Heavy and Normal
cycles. Always use Hi-Temp Scrub if you have hard water.
SANI RINSE™ Option
Select this option to raise the water temperature in the final rinse
to approximately 160°F (70°C). The SANI RINSE™ Option adds
heat and time to the cycle. This high temperature rinse sanitizes
your dishes and glassware in accordance with NSF/ANSI
Standard 184 for Residential Dishwashers. Certified residential
dishwashers are not intended for licensed food establishments.
NOTE:
SANI RINSE™ is an option with the Heavy and Normal
cycles. Only these sanitization cycles have been designed to
meet the NSF/ANSI requirements.
ENERGY SAVER™ Dry System
Select this option to dry dishes without heat. ENERGY SAVER™
Dry System is useful if you do dishes at night and unload in the
morning.
The dishes take longer to dry, and some spotting can occur. For
best drying, always use a liquid rinse aid. Some items (such as
plastics) may need towel drying.
NOTE:
Rinse Only automatically uses this option. ENERGY
SAVER™ Dry System is an option with all other cycles.
Control Lock
Use the Control Lock to prevent unintended use of the
dishwasher. You can also use the control lock feature to prevent
unintended cycle or option changes during a cycle.
When Control Lock is lit, all buttons are disabled.
NOTE:
The dishwasher door can be opened while the controls
are locked.
To turn on the Lock
Press and hold
for 4 seconds. Control Lock glows.
If you press any pad while your dishwasher control is locked, the
light flashes 3 times.
To turn off the Lock
Press and hold ENERGY SAVER™ Dry control for 4 seconds. The
light turns off.
Delay Hours
Select this option to run your dishwasher at a later time or during
off-peak hours. You can add items to the load anytime during the
delay countdown. After adding items, close the door firmly until it
latches. The delay countdown will not continue if the door is not
latched.
To delay the start
1.
Open the door.
2.
Select a wash cycle and options.
3.
Press
The delay light will glow.
4.
Press
5.
Close the door.
NOTE:
To cancel the delay, press 4 HOUR DELAY to turn the light
off.
IMPORTANT:
■
Operate your dishwasher only when you are at home.
■
If your home is equipped with a water softener, do not start
the dishwasher during the regeneration of the softener.
Status Indicators
Follow the progress of your dishwasher with the status
indicators.
Sanitized
If you select the SANI RINSE™ option, Sanitized glows when the
SANI RINSE™ cycle is finished. If your dishwasher did not
properly sanitize your dishes, the light flashes at the end of the
cycle. This can happen if the cycle is interrupted or the incoming
water temperature is too low. The light goes off when you open
and close the door.
Clean
CLEAN glows when a cycle is finished. The light turns on when
you open the door. The light turns off when you close the door or
press CANCEL.