Filter
Top Products
4-13
8. To remove the bimetal:
a) Unclip the bimetal from the evaporator
inlet tubing.
b) Follow the instructions that were sup-
plied with the replacement bimetal to
connect the wires.
Unclip Bimetal
9. To remove the defrost heater:
a) Remove the four hex-head screws from
the right evaporator cover mounting
bracket and remove the bracket.
Right Evaporator
Cover Bracket
e) Remove the foam block from the right
side of the evaporator.
b) Disconnect the two defrost heater wires
and the main terminal connector.
c) Unclip the bimetal from the evaporator
inlet tubing.
d) Remove the two top hex-head screws
and loosen the bottom screw on the
evaporator fan motor shroud, and re-
move the shroud and the two foam
inserts.
Bimetal
Terminal Connector
Evaporator Fan Motor
Shroud Screws
(2 of 3)
Right Foam Block
Do Not
Overbend Tubing
NOTE: Be very careful not to over-bend
the refrigerant tubing.
f) Lift the evaporator off the two bottom
hangers and remove the styrofoam air
block from the left side.
Left Styrofoam Block
Continued on the next page.
Defrost Heater Wires