Filter
Top Products
9
Install Duct Covers
NOTE: Remove the film from the vertical duct cover supports and
the duct covers.
1. Attach the vertical duct cover supports using 8 - 4 x 8 mm
screws.
2. Slide the upper duct covers into place, and insert 3 tabs on
each side of the duct covers into the mating slots of the
vertical duct cover supports. Slide the duct covers up until
the springs “click” and the tabs are locked in place.
3. Slide the lower duct covers over the upper duct covers.
4. Attach the lower duct covers together using a plastic bracket
at each top and bottom corner of the lower duct covers
(4 places).
Complete Installation
1. For non-vented (recirculating) installations only, install
charcoal filters over grille on blower housing. See the “Range
Hood Care” section.
2. Install metal filters. See the “Range Hood Care” section.
3. Check the operation of the range hood blower and light. See
the “Range Hood Use” section.
If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
NOTE: To get the most efficient use from your new range hood,
read the “Range Hood Use” section.
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
The range hood controls are located on the front side of the
canopy.
Control Panel
A. Screws
B. Vertical duct cover support
A. Upper duct cover
B. Spring
A. Upper duct cover
B. Lower duct cover
C. Plastic brackets
B
A
A
B
A
A
B
C
C
A. Louver holes (non-vented
[recirculating] installations only)
B. Duct covers
C. Lamp housings
D. Canopy
E. Grease filters
F. Grease filter handles
G. Control panel
A. Power decrease
B. Power increase
C. Display
D. Light
E. Timer
A
B
C
D
E
F
G
A
B
C
D
E