Filter
Top Products
10
Install Lower Chimney Cover
1. Slightly spread the sides of the cover apart and hook them
behind the upper chimney and the wall.
2. Attach the cover to the hood with 2 mounting screws.
3. Securely tighten screws.
For non-vented (recirculating) installations:
Insert the 2 vent grates into the openings on each side of the
lower chimney and fit them into the diverter outlets.
Check that the directional symbols point toward the top and front
of hood as shown.
Install Grease Filters
NOTE: Use 2 hands to install filter, one to pull and turn the knob,
the other to hold the filter in place so that it doesn’t fall.
1. Insert back edge of filter into rear channel of the filter
opening.
2. Pull out on knob and turn counterclockwise, position front
edge into place and release knob.
3. Repeat for remaining filters.
Complete Installation
Check Range Hood Operation
1. Press the light button (F) to turn on the light, press again to
turn light off.
2. Press the night light button (G) to turn off the night light, press
again to turn night light off.
3. Press the On/Off button (A) to turn the fan on. The speed
setting will appear in the display.
4. Press the “+” or “-” minus buttons to increase or decrease
the fan speed.
5. Press the On/Off button (A) to turn off the fan.
6. If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
NOTE: To get the most efficient use from your new range hood,
read the “Range Hood Use” section.
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
Control Panel
The range hood controls are located on the right-hand front
surface of the range hood.
Operating the Light
1. Press the light button (F) to turn on the light.
2. Press the light button (F) to turn off the light.
Operating the Night Light
1. Press the night light button (G) to turn on the night light.
2. Press the night light button (G) to turn off the night light.
Operating the Fan and Adjusting Fan Speed
The fan has 4 speeds, 1 (low), 2 (medium), 3 (medium-high), and
4 (high).
1. Press the On/Off button (A) to turn the fan on. The speed
setting will appear in the display.
2. Press the “plus” (+) or “minus” (-) buttons to increase or
decrease the fan speed.
3. Press the On/Off button (A) to turn off the fan.
10-Minute Boost Function
Press the “H” button to start the 10-minute boost function. The
fan motor will run on its highest speed (4) as the display counts
down from 10 minutes. At the end of 10 minutes, the fan will
return to the previously selected speed.
A.2 mounting screws
A.Vent grate
B.Front of hood
A
A
B
A.Fan motor on/off
B.Decrease fan motor speed
C.Increase fan motor speed
D.Electronic Display
E.10 minute timed boost
F. L i g h t
G.Night light
ABCDEFG