Filter
Top Products
8
2. Place the other chimney bracket on the wall so that its lower
edge is 16³⁄₁₆" (41.1 cm) from the ceiling or soffit and level.
Align the center notches of the bracket and the centerline.
Mark the centers of the bracket holes.
3. Drill pilot holes.
■ If installing into wood, drill 4 - ³⁄₃₂" (2.4 mm) pilot holes.
■ If installing into plaster or drywall, drill 4 - ³⁄₁₆" (4.8 mm)
pilot holes and insert drywall anchors flush with the wall.
4. Attach each bracket to the wall with 2 - #8 Phillips head
mounting screws. Tighten screws securely.
Complete Preparation
1. Determine and make all necessary cuts in the wall for the vent
system. Install the vent system before installing the range
hood. See the “Venting Requirements” section.
2. Determine the location where the power supply cable will be
run through the wall.
NOTE: For wiring flexibility, the terminal box is external to the
range hood motor. About 24" (61.0 cm) of wire connects the
terminal box to the range hood motor.
Check that the lower chimney cover will hide the selected
location.
3. Drill a 1¹⁄₄" (3.2 cm) hole at this location.
4. Mark and drill the terminal box mounting holes.
5. Pull enough power supply cable through the wall to allow for
easy connection to the terminal box.
Install Range Hood
1. Use a flat-blade screwdriver and tighten the 2 leveling screws
located close the range hood mounting brackets.
2. Use a Phillips screwdriver and remove the terminal box cover.
Set cover aside.
Vented Installations
Go to Step 6.
Non-vented (recirculating) Installations
3. Install the non-vented (recirculating) conversion kit ordered
for your range hood.
4. Fit the diverter over the vent motor exhaust outlet and push
down to seat on outlet. Check that the diverter exhaust
outlets are parallel with the vent motor sides so that they will
align with the vent cover openings in the lower chimney.
5. Install the 2 vent extension pieces onto the diverter pushing
them until they stop.
6. Using 2 or more people, lift the range hood and place the
mounting hood brackets over the mounting screws. Securely
tighten the screws.
7. Level the range hood. Adjust the 2 leveling screws (see
Step 1) as needed.
8. If not previously done, center the wiring hole in the terminal
box over the hole in the wall, mark the 2 terminal box
mounting holes. Drill holes as needed for your installation.
A.Leveling screw
A
A.Diverter
B.Vent motor
A.Diverter
B.Exhaust extension
A
B
A
B
WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.