Filter
Top Products
Side panel requirements
+I- IW tolerance
23-118” depth
protruding door
installation
23-718” depth
flush door
inslallaflon
I
I
Refrigerator
<
>
118” spacer
<=-
thickness
*
<’
<’
df,sA
I
sid
5132”
-+I
Side trim
spacers
L”
”
1
1. Attach three spacers from the
miscellaneous parts bag to the
top, middle and bottom of each
side of the refrigerator. Spacers
are required for ventilation.
side panel
suppo!l nailer
/
I I irlll I
112” side panel
recommended
2. A side panel support nailer
should be attached to the rear
wall on each side of refrigerator
Page 6
when 25” depth is available. If
less than 25” depth is available,
go to step 3.
If side panel is not inserted into
side trim, drill six equally-spaced
holes in each side trim.
Do Not drill into side of
cabinet. Attach side panels to
side trim using six screws on
each side.
Side panel thickness should be
112” minimum to prevent
“blousing” or warping.
-side panel
support nailer
l/2” side panel
recommended
* spacer
+ side trim
:F
I
3. If less than 25” depth is
available, side panel
installation will need to be
completed according to each
site’s restrictions.
One method is to attach side
panel to outside of side trim.
However, this will increase
width required. Drill holes into
side trim. Attach a wood support
to side trim. Attach side panel
to panel support nailer and
wood support. Cover wood
support with a panel piece to
match side panel.
toe panel
Yrhii
notches for
door hinges
/
4. Height of side panels depends
on your installation site. Side
panels may need to be notched
to clear door hinges. Side
panels may be cut to match toe
panel recess if desired.
Notch side panel only after
the installed height of the
refrigerator has been
determined.