Filter
Top Products
7. Attach outer panel to full front panel panel with the four
#10-16 x 3/8" hex head screws supplied in the literature
package.
8. Attach the panel assembly to the door by reinstalling the
two uppermost side screws; do not tighten screws
completely. This will hold the panel assembly in place on
the door frame.
3. Add shims as needed in the area shown to bring
dishwasher up to proper height.
NOTE: Shims must be securely attached to floor to
prevent their movement when the dishwasher is
operated.
11
2"
(5.1 cm)
6"
(15.2 cm)
2-3/4"
(7.0 cm)
2-3/4"
(7.0 cm)
shim
shim
2 screws
factory-supplied
full front panel
top edge
4 screws
full front panel
outer panel
hex head
screw
Install the door handle (on some models)
IMPORTANT: Do not scratch the front panel during this
procedure.
1. Remove the door handle and hardware bag containing
the setscrews and Allen wrench from the cardboard box.
2. Start set screws in handle.
3. Place handle on mounting studs with the set screws
facing down.
4. Push the door handle tightly against the door. Insert the
short end of the Allen wrench into the setscrews. Tighten
the setscrews 1/4 turn past snug. Retain Allen wrench with
Installation Instructions.
Allen
wrench
setscrew
(in bottom
of handle)
handle
mounting
stud
Install the door handle—Pro Line
®
series
1. Remove the Pro Line
®
series handle and two screws from
handle package.
2. Make sure plastic
spacers are still attached
to the door.
3. Attach the handle to the
factory-supplied full
front panel as shown.
plastic spacers
Install door panel—Pro Line
®
series
For top vented models with a factory-supplied stainless or
painted full front panel:
1. Remove the carton containing the factory-supplied full
front panel.
2. Remove the handle package from the front of the
shipping base.
3. With a TORX
®
screwdriver, remove three screws on both
sides, as shown; hold the outer panel up while removing
the screws. Save screws for reinstallation.
4. Gently set outer panel aside.
5. Lay the factory-supplied full front panel face down on a
protective non-scratching surface.
6. Place the outer panel on the back of the full front panel;
align screw holes.
3 screws
3 screws
outer panel