Filter
Top Products
3
INSTALLATION REQUIREMENTS
These instructions are intended as a general guide only for use by
qualified persons and do not supersede any national or local
codes in any way. Compliance with all local, state, or national
codes pertaining to this type of equipment should be determined
prior to installation.
Read this entire instruction manual, as well as the instructions
supplied in separate equipment, before starting the installation.
This hot water dispenser is not a water purifier. Some installations
may require a water filtering system to improve the quality of the
water.
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
Parts Needed
Parts Supplied
Remove parts from packages. Check that all parts were included.
Location Requirements
Faucet for the hot water dispenser requires a 1³⁄₈" (3.5 cm)
diameter opening in the sink or countertop. Faucet can be
installed in the existing opening for a sink spray hose. If the
faucet is not to be installed in the sink spray hose opening or
another existing opening, it is recommended that a qualified
installer be contacted to drill the hole through your sink or
countertop. Thickness of the sink or countertop must not exceed
1³⁄₄" (4.4 cm).
Cold water supply connection must be available. See “Water
Supply Requirements.”
Grounded 3 prong outlet is required. See “Electrical
Requirements.” The outlet should be located within 42"
(106.7 cm) of the hot water dispenser tank.
Plumbing connections must comply with all sanitary and
plumbing codes.
Water connections use easy-connect fittings which do not
require sealing compounds.
■ Adjustable wrench with
minimum opening of 1¹⁄₂"
(3.8 cm)
■ Phillips screwdriver
■ Tape measure
■ Pencil
■ Pliers
■ Tube cutter
■ ¹⁄₄" or 7 mm open-end
wrench
■ Bucket or pan
■ Screws or anchors for attaching the mounting bracket to
the wall
■ ¹⁄₄" (6.4 mm) O.D. copper or plastic tube
■ Saddle valve kit or other plumbing parts needed to connect
¹⁄₄" (6.4 mm) tube from the faucet easy-connect fitting to
the water supply line. If a saddle valve is used, do not use a
piercing type or ³⁄₁₆" (4.8 mm) saddle valve, which reduces
water flow and clogs more easily.
NOTE: Saddle valve kit or other plumbing parts used must
meet all local plumbing codes and ordinaces.
■ Faucet assembly
■ Water tank
■ Tank mounting bracket
■ Hose clamp