Filter
Top Products
11
Install Grill Grease Trays (on grill models)
1. Remove flame spreader. Pull forward slightly on the flame
spreader to release the tabs from the rear slots and lift out.
2. Cut and remove tie strap from rear of burner assembly.
3. Lift burner assembly up and out to remove.
4. Slide drip tray into opening on the right front side of the grill
basin. There are guides to assure correct placement of the
drip tray.
5. Insert the large grease tray all the way under the back edge of
the grill basin and hook it into the slots.
6. Insert the small grease tray all the way under the front of the
grill basin and hook it into the slots.
When the 2 grease trays are installed properly, the small
grease tray will hook over the large grease tray.
7. Insert the orifice tube on the front of the burner assembly into
the opening at the front of the grill basin and set burner
assembly into place.
8. Insert front tabs of the flame spreader into slots at the front of
the grill basin, then the rear tabs into the rear slots.
9. Check the surface burner and grill flames. Refer to
“Electronic Ignition System” in the “Complete Installation”
section.
10. Place the wave tray on top of the flame spreader.
11. Place the grill grate into position.
A. Grill front
B.Rear tabs and slots
A.Tie strap
A. Drip tray
A.Large grease tray
B.Slots
A
B
A
A
A
B
A. Large grease tray
B. Grease tray connection
C. Small grease tray
D. Slots
A. Front opening
A. Front tabs and slots
B.Rear tabs and slots
A
B
C
D
A
A
B