Filter
Top Products
25
To Remove:
1. Open oven door all the way.
2. Pull forward and down on the hinge latch on each side.
3. Close the oven door as far as it will shut.
4. Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away from
the oven door frame.
To Replace:
1. Insert both hanger arms into the door.
2. Open the oven door.
You should hear a “click” as the door is set into place.
3. Move the hinge levers back to the locked position. Check
that the door is free to open and close. If it is not, repeat the
removal and installation procedures.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate
■ Has a household fuse blown, or has a circuit breaker
tripped? Replace the fuse or reset the circuit breaker. If the
problem continues, call an electrician.
Cooktop will not operate
■ Is the control knob set correctly? Push in knob before
turning to a setting.
■ Is the Cooktop Control Lock set? See “Control Lock”
section.
Excessive heat around cookware on cooktop
■ Is the cookware the proper size? Use cookware about the
same size as the surface cooking area, element or surface
burner. Cookware should not extend more than ½" (1.3 cm)
outside the cooking area.
Hot surface indicator light stays on
■ Does the hot surface indicator light stay on after controls
have been turned off? See “Hot Surface Indicator Light(s)”
in “Cooktop Controls - Touch-Activated Custom Control
Temperature Management System” or “Cooktop Controls -
Standard Knobs” section, depending on your model.
Cooktop cooking results not what expected
■ Is the proper cookware being used? See “Cookware”
section.
■ Is the control knob or element controls set to the proper
heat level? See “Cooktop Controls - Touch-Activated
Custom Control Temperature Management System” or
“Cooktop Controls - Standard Knobs” section, depending on
your model.
■ Is the range level? Level the range. See the Installation
Instructions.
Oven will not operate
■ Is the electronic oven control set correctly? See “Glass
Touch-Activated Electronic Double Oven Control” section.
■ Has a delay start been set? See “Timed/Delay Cooking”
section.
■ On some models, is the Control Lock set? See “Control
Lock” section.
■ On some models, is the Sabbath Mode set? See
“Automatic Shutoff/Sabbath Mode” section.
Oven temperature too high or too low
■ Does the oven temperature calibration need adjustment?
See “Oven Temperature Control” section.
Display shows messages
■ Is the display showing “12:00”? There has been a power
failure. Clear the display. See “Display” in the “Glass Touch-
Activated Oven Control” section. On some models, reset the
clock, if needed. See “Clock” in the “Glass Touch-Activated
Electronic Double Oven Control” section.
■ Is the display showing a letter followed by a number?
Press OFF to clear the display. See “Display” in the “Glass
Touch-Activated Electronic Double Oven Control” section. If a
letter followed by a number reappears, call for service. See
“Assistance or Service” section.
Self-Cleaning cycle will not operate
■ Is the oven door open? Close the oven door all the way.
■ Has the function been entered? See “Self-Cleaning Cycle”
section.