Filter
Top Products
Installing the RTBUS-110 Round Table Connection Bus
7
7
5 Installing the RTBUS-110 Round Table Connection Bus
To install the RTBUS-110 perform the following steps:
1. Drill a hole in the table (see section
5.1).
2. Insert the unit through the hole and secure the unit to the table (see
section
5.2).
3. Connect the cables (see section
5.3).
5.1 Drilling a Hole in the Table
To drill an opening in the table:
1. Using any standard cup type drill bit with a diameter ranging from
110mm to 112mm (4.33in to 4.4in), drill a hole in the table in the
desired location.
Note: The thickness of the table should be 3in (76mm) or less.
2. Clean the table surface.
Take care not to damage the table.
Kramer Electronics is not responsible for any damage caused to the table