Filter
Top Products
English
7
1 Remove all of the various packaging, stickers or accessories from both the inside and outside of the kettle.
2 Adjust the length of the cord by winding it under the base. Wedge the cord into the notch. (fig 1)
1 TO OPEN THE LID, ACCORDING TO THE MODEL
- Hinged lid: press if necessary on the locking system and pull backwards. (fig 2)
- Assisted opening lid: press on the locking system and the lid lifts automatically (fig 3)
- Automatic opening lid: press the button at the top of the handle. (fig 4)
- Lockable lid: turn the lid to the left to unlock it and lift it. (fig 5)
To close the lid, press it down firmly or turn it to the right in the case of the lockable lid.
2 PLACE THE BASE ON A FLAT, STABLE, HEAT-RESISTANT SURFACE AWAY FROM WATER
SPLASHES AND ANY SOURCES OF HEAT.
Your kettle must only be used with the base that matches it and its own anti-scale filter.
3 FILL THE KETTLE WITH THE DESIRED AMOUNT OF WATER. (FIG 6)
You can fill the kettle through the spout, which ensures better maintenance of the filter. As a minimum, cover the
element (or the bottom of the kettle) with water.
• Never fill the kettle when it is on its base.
• Do not fill it above the maximum level, or below the minimum level. If the kettle is too full, boiling water may spill
out.
• Do not use without water.
• Check that the lid is closed properly before use.
4 POSITION THE KETTLE ON ITS BASE. PLUG IT INTO THE MAIN SOCKET.
5 TO START THE KETTLE
Press the on/off button positioned on the top or the bottom of the handle according to the model. (fig 7)
6 THE KETTLE MAY HAVE AN INTERNAL LIGHT, DEPENDING ON MODEL
7 THE KETTLE WILL SWITCH OFF AUTOMATICALLY
as soon as the water reaches boiling point or the chosen temperature. You can stop it manually, before removing it
from its base to pour the water. Depending on the model, the interior light and the indicator light will go out when
the water reaches boiling point. Make sure that the on/off button is in the off position after boiling and that the
kettle has switched off before removing it from its base.
Throw away the water from the first two/three uses as it may contain dust. Rinse the kettle and the filter separately.
Do not leave water in the kettle after use as this quickens the formation of scale.
BEFORE USING FOR THE FIRST TIME
USE
Notice nafta US.qxp:Nafta-usa 8/07/09 11:00 Page 7