Filter
Top Products
English
10
ASSEMBLING YOUR CITRUS PRESS
ENSURE THE ON/OFF SELECTOR KNOB IS IN THE OFF
POSITION AND THE CITRUS PRESS IS NOT PLUGGED IN
WHEN ASSEMBLING.
Remove the small lever pin
(B)
in the bag attached to the pressing
lever
(A) - Fig.4
.
Holding the black portion of the pressing lever
(A)
horizontally,
slip the silver end of the pressing lever
(A)
into the notches at the
top of the citrus press arm
(L)
. Note the hole on the silver end of
the pressing lever
(A)
should be on the right side
- Fig.3
.
While holding the pressing lever
(A)
in place, align the hole on
the right side of the lever with the hole in the shaft. Hold the black
end of the lever pin
(B)
, and push the lever pin
(B)
into the hole.
The lever can now be moved up and down.
Put the lever
(A)
in its upper position.
Rest the lever in the upright position so that the round notches on
the center of the underside of the handle are visible. Press the
clear splash guard
(C)
onto the round notches, it will click in place.
Align the notches on the black fruit press
(D)
with the metal bar in
the center of the round notches, then turn clockwise one quarter
turn to lock into place. Once locked in place, the fruit press
(D)
cannot be pulled off, but can be moved up and down
- Fig.5
.
Slip the drip tray
(J)
and drip tray grid
(I)
in place
- Fig.6
.
Rest the lever in the up position. Slide the clear bowl
(G)
onto the
black plastic shaft of the citrus press. Align the clear bowl
(G)
so
that the plastic pouring spout
(G1)
is on the front, to the left of
the center (7:00 position), then turn counter-clockwise so that
the pouring spout
(G1)
is centered and the bowl is locked in
place
- Fig.7
.
Place the pulp filter
(F)
inside the clear bowl
(G) - Fig.8
.
Slide the juicing cone onto the center of the black axis in the
center of the pulp filter
(F)
and check that the cone rotates
smoothly both clockwise and counter-clockwise.