Filter
Top Products
10
6) FITTING THE HOB
The hob is equipped with a special seal to avoid
any infiltration of liquid into the unit. To apply this
seal correctly, please follow the instructions given
below carefully:
- remove all the mobile parts of the hob.
- Cut the seal into 4 strips of the lengths suitable
to fit it along the 4 sides of the glass.
- Turn the hob upside down and place the
adhesive side of the seal “E” (fig. 8) correctly
under the edge of the hob so that the outer edge
of the seal perfectly matches the outer perimeter
edge of the glass. The ends of the strips must
match without overlapping.
- Stick the seal to the glass evenly and securely,
using your fingers to press it into place.
- In order to avoid accidental contact with the
surface of the box of the overheated hob during
use, it is necessary to install a wooden divider at
a minimum distance of 150 mm from the top,
fastening it in place with screws. (fig. 6).
- To fasten this product to the supporting structure,
we advise you not to use mechanical or electrical
screwdrivers and to exercise moderate pressure
by hand on the fastening hooks.
FIG. 8
FIG. 9
INSTALLATION