Filter
Top Products
4
Manual No. 700-372M 6/14/05
Land Pride
Assembly Instructions
■
Gearbox Assembly
Refer to Figure 7 on page 4:
1. Assemble right angle gearbox (#12) to mounting
bracket (#2) with four 5/16"-18 x 3/4" lg. GR5 hex
head cap screws (#5) and lock washers (#10).
Tighten cap screws to 17 ft. lbs. of torque.
2. Attach gearbox mounting bracket (#2) to the newly
drilled 11/32" holes in the engine mounting plate (#1)
with two 5/16"-18 x 3/4" lg. GR5 hex head cap screws
(#5A), flat washers (#9A) and hex head nylock nuts
(#8A). Do not tighten.
3. Reassemble front drive shaft (#11) and 3/16" x 7/8"
key (#3) to the gearbox. Do not tighten 3/8" hex
head cap screw (#6).
4. Reassemble gearbox (#12) and 3/16" sq. key (#4) to
gearbox coupler (#14). Torque 1/4"-28 coupler cap
screws (#7) to 10 ft. lbs.
5. Torque 3/8" hex head cap screw (#6) to 49 ft. lbs.
6. Torque the two hex nylock nuts (#8A) to 17 ft. lbs.
7. While holding gearbox mounting bracket (#13) tight
against the transmission support bracket (#16),
tighten the four 5/16"-18 hex head cap screws (#5D)
to 17 ft. lbs. of torque.
8. Center punch the center of the two slots in mounting
bracket (#13).
9. Drill 1/8" pilot holes in the transmission support
bracket (#16) at the center punch marks. Be careful
not to drill through the transmission housing.
10. Redrill the pilot holes to 11/32" diameter. Be careful
not to drill through the transmission housing.
11. Attach bracket (#13) to transmission support (#16):
• NT Trekers:
a. Install two 5/16" x 3/4" lg. hex head cap screws
(#5B & 5C), flat washers (#9B) and hex head
nylock nuts (#8B). Torque nuts to 17 ft. lbs.
• ST Trekers:
a. Install 5/16"-18 x 3/4" lg. GR5 hex head cap screw
(#5B), flat washer (#9B) and hex head nylock nut
(#8B). Do not tighten.
b. Remove 5/16" muffler mounting hardware (#17, 18
& 19) on the left side of vehicle only. Discard bolt
#17.
c. Attach support bracket (#15) to the under side of
transmission support (#16) with new 5/16"-18 x 1"
lg. GR5 hex head cap screw (#20) and existing
5/16" flat washer #18 & nylock nut (#19). Do not
tighten.
d. Insert 5/16"-18 x 1" lg. GR5 hex head cap screw
(#20), flat washer (#9B) and hex head nut (#8B).
e. Tighten nuts (#8B & #19) to 17 ft. lbs. of torque.
Refer to Figure 1 & Figure 2 on page 1:
12. Reinstall existing shock with M14-2.00 hex nut and
cap screw. Torque nut to 105 ft. lbs.
13. Lower vehicle to the ground and remove wheel
chocks.
Gearbox Removal (Muffler Not shown For Clarity)
Figure 7
23681