Filter
Top Products
- 7 -
3-4 DEF' CONTROL ASSY
Def control ASM consists of Defrost Sensor and FUSE–M.
Defrost
Sensor
functions to defrost automatically and it is
attached to the Evaporator and the metal side of the case
senses Temp.
Fuse-M is a kind of safety device for preventing over-
heating of the Heater when defrosting.
At the temperature of 77°C, it stops the emission of TEMP
from the Defrost Heater.
1. Pull out the shroud-F after removing the Grille Fan.
(Figure 13)
2. Separate the connectors connected with the Def Control
ASM and replace the Def Control ASM after cutting the
Tie Wrap. (Figure 14)
3-5 LAMP
3-5-1 Freezer room lamp
1. Unplug the power cord from the outlet.
2. Remove the room lamp lid by taking down while pulling
it forward with your hand after inserting finger into the
inside hole as shown in (figure 16).
3. Remove the lamp by turning it counterclockwise.
4. Assemble in reverse order of disassembly. Replacement
bulb must be the same specication as original.
3-5-2 Refrigerator room lamp
1. Unplug the power cord from the outlet.
2. Remove refrigerator shelves.
3. Remove the room lamp lid by taking down while pulling
forward with your hands as shown in (figure 17).
4. Turn the lamp counterclockwise.
5. Assemble in reverse order of disassembly. Replacement
bulb must be the same specification as original.
3-6 CONTROL BOX-R
1. First, remove all shelves in the refrigerator and Control
Box-R by loosening 1 screw.
2. Loosen 2 screws fixing the Control Box-R to the Inner
Case after detaching the cap screw.
3. Remove the Control Box-R by pulling it downward.
SHROUD-F
Figure 13
FAN
DEF CONTROL ASM
Figure 14
FREEZER ROOM LAMP REFRIGERATOR ROOM LAMP
Figure 16
Figure 17
MULTI FLOW
DUCT
Figure 18