Filter
Top Products
20
SETTING THE CONTROLS
1 2 3
TEMPERATURE
• Your refrigerator has a control pad inside
the refrigerator compartment that lets you
regulate the temperature in the freezer and
refrigerator compartments.
• Initially set the refrigerator control at 37°F (3°C)
and the freezer control at 0°F (-18°C).
Leave it at these settings for 24 hours (one day)
to stabilize. Then adjust the compartment
temperature as desired.
• Refrigerator Temp Control: 33°F to 46°F
(0°C to 8°C)
The lower the number setting, the colder the
refrigerator compartment will become.
• Freezer Temp Control: -6°F to 8°F (-21°C to -13°C)
When the setting is at a lower number, the freezer
compartment becomes colder. The refrigerator
compartment becomes warmer because less cold
air flows into the refrigerator.
ICE PLUS
• When you press the ICE PLUS button, the graphic
[ ] will light up in the display and it continues
for 24hours. It will automatically shut off after
24hours have passed.
Or you can stop this function manually by pressing
the button one more time.
• This function increases both icemaking and freezing
capabilities.
NOTE: If you want to change °F to °C, press and
hold FREEZER key and REFRIGERATOR key over
5 seconds at the same time. and if you want to
change °C to °F, hold them for 5 seconds again.
ALARM
• When the power is connected to the refrigerator,
door alarm is initially set ON and door alarm display
will show [ ] (ON).
• When either refrigerator or the freezer door is left
open for more than 60 seconds, the alarm will ding
to let you know the door is open.
• When you close the door, the door alarm will stop
dinging.
• If you want to disable the door alarm function, press
[ ] button then the door alarm display will
switched to [ ] (OFF).
wCAUTION
Display mode setting and its cancellation
• With the refrigerator door open, keep pressing the
REFRIGERATOR Button and ICE PLUS Button
more than 5 seconds, then it goes to the display
mode with Special Beep Sound with special beep
sound.
• Perform the same way again to cancel the display
mode.
• All freezing unit will be turned off at display mode
(Exceptions: Lamp, Display)
1 3
2