Filter
Top Products
33
HOW TO USE
ENGLISH
FCC (Regulatory information/warning)
§15.19
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
§15.21
Any changes or modifications not expressly
approved by the party responsible for compliance
could void the user’s authority to operate this
equipment.
§15.105
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV
technician for help.
§2.1091
The antenna(s) must be installed such that a
minimum separation distance of at least 20 cm is
maintained between the radiator (antenna) and all
persons at all times. This device must not be co-
located or operating in conjunction with any other
antenna or transmitter.
Labeling
This device includes the following module.
Contains FCC ID: BEJ-LGHALCW1404
Contains IC: 2703N-LGHALCW1405
IC (Regulatory information/warning)
RSS-GEN Section 7.1.3
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR
d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes:(1)
l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le
fonctionnement.
RSS-102 RF Exposure
L’antenne (ou les antennes) doit être installée
de façon à maintenir à tout instant une distance
minimum de au moins 20 cm entre la source de
radiation (l’antenne) et toute personne physique.
Cet appareil ne doit pas être installé ou utilisé en
conjonction avec une autre antenne ou émetteur.