Filter
Top Products
Installation instructions for glass tray
To Install:
1. Place the guide tray on the oven cavity bottom. The rollers on the shaft should fit inside the guide
tray bottom groove. (see figure 1, 2-1,2-2)
2. Place the rotating ring on the guide tray. (see figure 3)
3. Place the glass tray on the rotating ring. Fit the rollers of the shaft between the raised, hollowed
groove of the glass tray bottom. The rollers on the rotating ring should fit inside the glass tray
bottom ridge. (see figure 4-1,4-2)
NOTE: IF NOT INSTALL THE GLASS TRAY EXACTLY, THAT CAN MAKE A NOISE.
Figure 1 Figure 2=1 Figure 2=2
Figure 3 Figure 4=1 Figure 4=2
(the back of guide tray)
Using Oblong dish
When using an oblong dish, don't forget to place it in the center of the guide tray, or poor
performance will result.
Oblong dish which is smaller than 13 inches should be placed on the glass tray. Dishes larger than
13 inches should be placed on the raised edge of the guide tray not allowing it to sit on the glass tray.
Otherwise, poor performance will result.
Figure 5 Figure 6 Figure 7