Filter
Top Products
WATER FILTER
It is recommended that you replace the filter when the
water filter indicator light turns on or your water dispenser
or ice maker performance decreases noticeably.
After changing the water filter cartridge, reset the water
filter status display and indicator light by pressing and
holding the button for 3 seconds.
1. Remove the old cartridge.
If you are replacing the cartridge, first remove the old
one. Open the cartridge cover by pressing in on the tab
(1) at the front and pulling down (2).
Rotate the knob of the cartridge counter clockwise until it
clicks forward.
Pull out the cartridge.
NOTE: There will be water in the cartridge. Some spilling
may occur.
2. Replace with a new cartridge.
Take the new cartridge out of its packaging and remove
protective cover from the o-rings.
With cartridge knob in the vertical position, push the new
filter cartridge into the cover until it stops.
If you can’t turn the filter from side to side, it isn’t fully
inserted. Push it in firmly and use its handle to twist the
cartridge clockwise about 1/4 turn. You will hear a snap
when it clicks into place.
3. Flushing the Water System After Replacing Filter
Dispense water through the water dispenser for 3 minutes
to purge the system.
NOTE: To purchase replacement water filter cartridges,
visit your local appliance dealer or part distributor. You
can also visit our website : www.lgappliances.com or call
1-877-714-7481. The replacement water filter cartridge’s
part number is 5231JA2006B.
USING YOUR REFRIGERATOR
24
push
push
Filter
Fresh
2
1 1
push
push
Filter
Fresh