Filter
Top Products
30
CONNECTING THE WATER LINE
9. CONNECT THE TUBING TO THE
REFRIGERATOR
Removing and Replacing Valve Cover
NOTE:
• Before making the connection to the refrigerator, be
sure the refrigerator power cord is not plugged into
the wall outlet.
1. Loosen screw on top of plastic cover.
2. Lift off the cover by slightly pushing up.
3. Place a compression nut and a ferrule(sleeve) onto
the end of tubing.
4. Insert the tube into the valve and fasten with wrench
as shown in the figure below.
ww
CAUTION: Check to see if water dripping occurs at
water line connections.
5. Bend the tube upwards and fasten it into the clamp
provided to hold it in position. Replace the cover
and tighten the cover screw.
Tubing
Tubing
Compression Nut
Ferrule (sleeve)
Tubing
Clamp