Filter
Top Products
CRISPER COVER WITH LATTICE ON INNER
SURFACE
To remove the crisper cover:
1. Remove both crisper drawers.
2. While holding the crisper cover support (2), pull the
cover up and out(1).
WARNING: Be careful when handing glass cover since
glass is not attached to cover.
USING YOUR REFRIGERATOR
21
USING YOUR REFRIGERATOR
To remove the crisper:
1. Slide crisper straight out to the stop.
2. Lift the front of the crisper, then pull it out to remove.
3. Replace the crisper by sliding it back in fully past the
drawer stop.
To remove the lattice on inner surface:
1. Remove crisper cover (as illustrated above).
2. Hold the glass cover and turn the crisper cover over.
3. For each lattice hold lattice and pull sides of the cover
outward to remove lattice.
To replace lattice on inner surface:
1. For each lattice insert middle tab in 1 (closed to glass
cover)and pull sides of the cover to insert lattice.
1
2
2
3
1
To remove the glass:
1. Lift up the glass after inserting a screwdriver under the
criper cover.
2. Pull up and out.