Filter
Top Products
Installation
13
Antenna or Cable Service without a Cable Box Connections
For optimum picture quality, adjust antenna direction if needed.
Connection & Viewing Setup
1. Set VCR switch to 3 or 4 and then tune TV to the
same channel number.
2. Insert a video tape into the VCR and press PLAY
on the VCR. (Refer to the VCR owner’s manual.)
Connection & Viewing Setup
1. Select 3 or 4 with channel switch on cable box.
2. Tune the TV channel to the same selected output
channel of cable box.
3. Select channels at the cable box or
with the cable box remote control.
- If your cable service does not require separate converter box please following the
instructions for an antenna connection above.
- For further cable TV information, contact a local cable service provider.
After hooking up the connection turn the TV on
and preform a channel search. On the remote
press menu, Auto program will be highlighted,
and then press right(Volume Up)twice.
In a poor signal area to improve picture quality,
purchase and install a signal amplifier.
If the antenna is not installed properly, contact
your dealer for assistance.
Antenna Connection
VCR Setup
Cable TV Setup
External Equipment Connections
wall antenna
socket
VHF antenna
UHF antenna
outdoor
antenna
Single-family Dwellings /Houses
(Connect to wall jack for outdoor antenna)
Be careful not to bend the bronze wire when
connecting the antenna.
Bronze Wire
Bronze Wire
RF coaxial wire (75 ohm)
Turn clockwise to tighten.
Multi-family Dwellings/Apartments
(Connect to wall antenna socket)