Filter
Top Products
Care and Maintenance
25
How to Dismantle Parts
Freezer
Compartment
Lamp
Dispenser Lamp
Freezer
Compartment
Shelf
Door Rack and
Support
Ice Storage Bin
After Dispenser
Is Used
Seperate the lamp by pulling it out, and then
remove the lamp. Max. 15 W refrigerator bulb
is used and can be purchased at a service
center.
To remove a shelf, lift the left part of the shelf
a bit, push it to direction , lift the right part to
direction , and take it out.
Lift the door rack holding both sides and
pull it in direction .
The water collector has no self-drainage
function. It should be cleaned regularly.
Remove the cover by pulling the front side of
water collector cover and dry it with a cloth.
Hold the ice storage bin as shown in the figure
to the right and pull it out while slightly lifting
it.
It is recommended not to dismantle the ice
storage bin unless it is necessary.
Use both hands to remove the ice bin to avoid
dropping it.
If the ice bin does not slide into place easily,
twist the drive device slightly.
•
Dismantling is done in the reverse sequence of assembly.
Be sure to unplug the power plug before dismantling and assembly.
Never apply severe force to dismantle parts. Parts may be damaged.
NOTE
To remove the lamp cover pull out firmly on the
lamp cover and rotate. This should expose the bulb
.
Turn the bulb counterclockwise. Max. 40 W
refrigerator bulb is used and can be purchased at a
service center.