Filter
Top Products
1
3
2
DESIGN-A-DOOR
1. Design-A-Door bin can be moved side to side by sliding
right or left.
2. To remove the Design-A-Door bin,
lift up from the bottom of
the bin unclicks
and pull
straight out.
3. To replace the bin,
slide it in above the desired
Support slot and firmly push down until it locks in place.
WARNING: Be sure that the design-A-Door bins have clicked
into place. Otherwise, the bins may fall.
USING YOUR REFRIGERATOR
DOOR BINS
The door racks may be removed for easier cleaning.
Snap-On Door Bins
To remove the bins:
1. Remove all items in the door bins.
2. Push the rack away from the inside wall of the door (A)
and lift up the door bin (B).
To replace the racks:
1. Hold either end of the door bin against the inside wall
of the door.
2. Push down the door bin end until it locks in place.
A
B
19
NOTE: Do not adjust a bin that is loaded with food.
To remove the crisper cover:
1. Remove both crisper drawers.
2.
While holding the crisper cover support (2), pull the cover
up and out (1).
CRISPER COVER WITH LATTICE ON INNER
SURFACE
WARNING: Be careful when handing glass cover since
glass is not attached to cover
1
2
1. Remove crisper cover (as illustrated above)
2. Hold the glass cover and overturn crisper cover
3. For each lattice hold lattice and pull sides of the cover
outward to remove lattice.
1. For each lattice insert middle tab in 1
(closest to glass cover) and pull sides of the cover to
insert lattice.
To remove lattice on inner surface
To replace lattice on inner surface,:
Warning: Somebody can be hurt if Design-A-Door bins are not
firmly assembled.
NOTE: Do not adjust a bin that is loaded with food.
4, .
Make sure that if all bins are correctly assembled so that
they don´t fall out of door.