Filter
Top Products
12
INSTALLATION INSTRUCTIONS
7. ADJUST THE SURFACE BURNER LOW FLAME
(SIMMER) SETTING
For all surface burners except for the center
burner
Only For the center burner
1. Light all surface burners except for the center
burner.
2. Turn the knob on the burner being adjusted to
“LO”(LOW).
3. Remove knob.
4. Insert a small, flat bladed screwdriver into the
valve stem as shown in Fig.2.
5. Turn the adjustment screw until the flame
reaches the desired size.
6. Replace the knob.
Fig. 2
Center adjustment screw
7. Test The Flame Stability.
Turn the knob from “HI” to “LOW” quickly.
With the burner on a “LOW” setting, open
and close the oven or cabinet door quickly.
If the flame is extinguished by the air currents
created by the door movement, increase
the flame height and test again.
lf the flame goes out, increase the flame
size and test again.
8. Repeat steps 1 - 6 for each surface burner
except for center burner.
Test 1 :
Test 2 :
15. Test The Flame Stability.
Turn the knob from “HI” to “LOW” quickly.
With the burner on a “LOW” setting, open
and close the oven or cabinet door quickly.
If the flame is extinguished by the air
currents created by the door movement,
increase the flame height and test again.
If the flame goes out, increase the frame
size and test again.
Test 1 :
Test 2 :
1. Disconnect power to appliance.
2. Remove grates, burners caps, burner heads and
knobs.
3. Remove the all the screws on the cooktop by
philips screwdriver.
4. Remove cooktop by lifting up.
5. Remove LED lamp module of the center valve
by unclipping. In this case, the ignition switch
should be positioned properly.
6. Replace the cooktop back and secure the screws
of the cooktop.
7. Position center burner head, center burner cap,
center grate, center knob.
8. Connect power to appliance.
9. Light center burner.
10. Turn the knob on the burner being adjusted
to “LO”(LOW).
11. Remove knob.
12. Using a small, flat bladed screwdriver insert
into the hole next to the valve stem to adjust
outer flame as shown in Fig.3.
13. Turn the adjustment screw until the flame
reaches the desired size.
14. Replace the knob.
Adjustment screw next to the valve shaft
Fig. 3
16. After low flame setting, turn off the burner.
17. Disconnected power to appliance.
18.
Remove knob, grate, burner cap, burner head.
19. Remove all screw of the cook top.
20. Remove cook top by lifting up.
21. Reposition center LED lamp module by
hooking.
22. Reposition cook top and secure all screws of
cook top.
23. Reposition burner heads, burner caps, grates
and knobs.
24. Connect power to appliance.