Liebherr 180613 7085462-00 Refrigerator User Manual


 
With the top drawer
removed:
u
to remove cold storage
accumulators: take hold of
the cold storage accumu-
lator at the side and press
it down for removal.
5.6.10 IceMaker*
The IceMaker is in the top drawer of the freezer compartment.
The drawer is marked "IceMaker".
Make certain that the following conditions are met:
-
The appliance is level.
-
The appliance is connected.
-
The freezer compartment is switched on.
-
The IceMaker is connected to the water supply.
Switching on the IceMaker*
Fig. 13
u
Pull out the drawer.
u
Press the On/Off button
Fig. 13 (1)
so that the LED
Fig. 13 (2)
shines.
u
Push in the drawer.
w
The IceMaker symbol
Fig. 2 (18)
shines.
Note
u
The IceMaker produces ice cubes only if the drawer is fully
closed.
Producing ice cubes*
The production capacity depends on the freezer temperature.
The lower the temperature, the more ice cubes can be
produced in a specific period.
The ice cubes drop from the IceMaker into the drawer. When a
certain filling level has been reached, no further ice cubes are
produced. The IceMaker does not fill the drawer right up to the
brim.
If large quantities of ice cubes are needed, the complete
IceMaker drawer can be exchanged for the adjacent drawer.
When the drawer is closed, the IceMaker automatically re-
commences production.
Once the IceMaker has been switched on for the first time, it
may take up to 24 hours until the first ice cubes are produced.
Note
When the appliance is used for the first time and if it has been
out of use for a long time, particles may collect in the IceMaker
and/or water conduit.
u
Therefore do not use or consume the ice cubes made in the
first 24 hours.
Setting the water intake time*
The opening time of the IceMaker valve can be set if, for
example, the water pressure in the pipe is too low or too high.
The water intake time can be set in stages from E1 (short intake
time) to E8 (long intake time). The intake is preset at E3.
u
To activate the setting mode: press the SuperFrost button
Fig. 2 (12)
for about 5 s.
w
The display indicates c.
w
Themenu symbol
Fig. 2 (16)
shines.
u
Using the Up setting button, freezer compartment
Fig. 2 (10)
and Down setting button, freezer compartment
Fig. 2 (11)
select E.
u
To confirm: briefly press the SuperFrost button
Fig. 2 (12)
.
u
To increase the water intake time: press the Up
setting button, freezer compartment
Fig. 2 (10)
.
u
To reduce the water intake time: press the Down
setting button, freezer compartment
Fig. 2 (11)
.
u
To confirm: press the SuperFrost button
Fig. 2 (12)
.
u
To deactivate the setting mode: press the On/Off button,
freezer compartment
Fig. 2 (8)
.
w
The temperature is indicated again in the temperature
display.
Switching off the IceMaker*
If no ice cubes are needed, the IceMaker can be switched off
independently of the freezer compartment.
When the IceMaker is switched off, the IceMaker drawer can
also be used for freezing and storing food.
u
Press the On/Off button for about 1 second until the LED
goes out.
w
The IceMaker symbol
Fig. 2 (18)
goes out.
u
Clean the IceMaker.
w
This ensures that no water or ice remains in the IceMaker.
6 Maintenance
6.1 Defrosting with NoFrost*
The NoFrost system automatically defrosts the appliance.
Refrigerator compartment:
The defrost water evaporates due to the compressor heat.
u
Regularly clean the drain opening to allow the water to flow
away (see 6.3) .
Freezer compartment:
The moisture condenses on the evaporator, is periodically
defrosted and evaporates.
u
The appliance does not have to be manually defrosted.
6.2 Manual defrosting*
The refrigerator compartment is defrosted automatically.
The defrost water evaporates as a result of the heat of the
compressor. Drops of water on the rear wall are perfectly
normal.
u
Regularly clean the drain opening to allow the water to flow
away (see 6.3) .
A layer of frost or ice can build up in the freezer compartment
after a long period of operation.
The layer of frost or ice builds up faster if the appliance is
opened often or if the food is warm when placed inside.
However, a thick layer of ice will increase the appliance‘s
energy consumption. You should therefore defrost the appli-
ance regularly.
CAUTION
Risk of injury and damage as a result of hot steam!
u
Do not use electric heaters or steam cleaners, naked flames
or defrosting sprays for defrosting.
u
Do not remove ice using sharp instruments.
u
Switch on SuperFrost one day before defrosting.
w
The frozen goods are provided with a "cold reserve".
u
Switch off the appliance.
w
The temperature display goes out.
w
If the temperature display does not go out, the child lock
function (see 5.1) is active.
Maintenance
11