Filter
Top Products
OPERATION
5
BFI/BF1055 (7082 244-00)
Safety Regulations
The appliance complies with UL250 and is designed
to cool, freeze and store food and to make ice (if
equipped). It is designed as a household appliance.
If used commercially, the relevant regulations on
commercial use must be observed.
The appliance is set to operate within specific
ambient temperature limits according to its climate
rating. These temperature limits should not be
exceeded. The correct climate rating for your
appliance is indicated on the model plate.
This is explained as follows:
Climate
Rating Set for Ambient Temperatures of
SN 50°F to 90°F (10°C to 32°C)
N 61°F to 90°F (16°C to 32°C)
ST 65°F to 100°F (18°C to 38°C)
T 65°F to 109°F (18°C to 43°C)
- The refrigerant circuit has been tested for leaks.
- The appliance complies with current safety
regulations and EC directives 73/23/EEC and
89/336/EEC.
We recommend cleaning the appliance before
turning it ON for the first time. See Cleaning.Turn
ON the appliance several hours before loading it
with frozen food for the first time. Do not load with
frozen food until the temperature shows
approximately 0°F (-18°C).
Do not allow children to play with the
appliance. Children must not climb, sit or
stand on the shelves, drawers or door.
Turning the Appliance ON and
OFF
- Figure 1
Clean the appliance before turning it on for the first
time. See Cleaning.
Allow the appliance to operate approximately two
hours before placing food in it. DO NOT place
frozen food in the freezer until the temperature
shows at least 0°F. The refrigerator and freezer
compartments can be operated separately.
1. Turning ON: Press the Refrigerator ON/OFF
button (Fig. 1, 9) and the Freezer ON/OFF
button (Fig. 1, 3) so the Temperature Displays
(Fig. 1, 1) and (Fig. 1, 7) light up or
“flash.”
!
WARNING
• The interior light will turn ON when the
refrigerator door is open.
• The freezer compartment display will display
lines until a temperature less than 32°F (0°C) is
reached.
Setting the Temperature
- Figure 1
The appliance is pre-set for normal operation. We
recommend temperatures of 34°F (+1 °C) in the
BioFresh compartment and 0°F (-18 °C) for the
freezer.
The appliance is pre-set for normal operation. We
recommend temperatures of 34°F (+1°C) in the
BioFresh compartment and 0°F (-18°C) in the
freezer compartment.
To reduce the temperature:
Press the (DOWN) button; (8) on left for
BioFresh compartment and (2) on right for the
freezer compartment.
To increase the temperature:
Press the (UP) button.
The temperature in the BioFresh compartment is
controlled automatically, between 33°F to 35°F (0°C
and 2°C). If you want a higher or lower
temperature, for example, for storing fish, you can
alter the temperature setting in the BioFresh
compartment. The setting range is displayed as
between
b1
and
b9
. The default factory setting is
b5
.
The temperature can be changed by ± 5
increments, displayed in the temperature display.
Note
By decreasing the temperature, b4 to b1,
minus temperatures can be reached and the
food will freeze slightly.
For the freezer compartment, the setting range is
displayed between 7°F and -14°F (-14°C and -
26°C). Whether you can obtain the lowest freezer
temperature depends on where the appliance is
positioned (if it is located in an area with a high
ambient temperature it will not reach the lowest
temperature).
While you are entering the temperature, the set
temperature will flash on the display.
When you press the temperature setting buttons for
the first time, the most recent setting is displayed.
* Depending on model and options
7082_244_00_Use Manual.qxd 10/21/2004 8:05 AM Page 5