Filter
Top Products
15
C 16/CI 16
A delight in freshness
BLOCKING FOR SAFETY
1. Secure the refrigerator in place so it does not tip
forward when the fully stocked door is opened.
2. Measure the distance from the floor to the upper
edge of the unit.
3. Locate and mark two wall studs against the wall
where the refrigerator will be located. The space
between the unit top and the bottom of the
brackets must not be more than 1/4" (0.635 cm).
4. Make sure the screws extend a minimum of 1"
(2.54 cm) into each of the wall studs.
5. Make sure the anti-tip brackets extend at least 3"
(7.62 cm) over the unit and are securely in place.
IMPORTANT
The anti-tip brackets can be installed in either
direction or closer together. Always position
the anti-tip brackets as wide apart as
possible, but make sure they are anchored to
two studs.
6. Using the front and rear levelers, raise the unit
until it makes contact with the brackets. Make
sure the front levelers are firmly on the floor to
prevent appliance from tipping forward.
IMPORTANT
If your unit is positioned in between the wall
studs, a board can be secured to the wall.
Make sure the board is secured to the studs
with screws that will penetrate into the studs a
minimum 1" (2.54 cm). The board should be a
minimum of 1" x 6" (2.54 cm x 15.24 cm) and
long enough to secure both ends to the wall
studs.
Figure 13
Wall Stud
Screws
Bracket
min 3"