Filter
Top Products
11
operatIon
Setting the Temperature - Figure 7
To reduce the temperature: Press the Down but-
ton.
To increase the temperature: Press the Up button.
- While you are entering the temperature, the set
temperature will flash on the display.
- You can change the settings in increments of
1°F (1°C) by briefly pressing the button again.
The electronic controls will switch over automati-
cally about five seconds after the last time you
pressed the button. The actual temperature will
display.
Figure 7
If F3, F4 or HE appears in the display, the appli-
ance has a fault. Contact your nearest customer
service representative.
Operating and
Control Elements - Figure 5
Figure 5
1
Temperature display
2
Temperature setting buttons
3
Alarm Off button
4
Childproof lock symbol
5
On/Off button
6
Appliance is defrosting
Turning the Appliance
On and Off
- Figure 6
Clean the appliance before turning it on for the first
time. See Cleaning.
Connect the appliance to the dedicated outlet.
• To turn the appliance on: Press the On/Off but-
ton until the display lights up.
• To turn the appliance off: Keep the On/Off but-
ton pressed for three seconds so that the tem-
perature display goes out.
Figure 6
Audible Warning Signal - Figure 8
- The audible warning signal sounds when the
door is open for longer than about 180 seconds.
The audible warning device is turned off by
pressing the Alarm button.
- The audible warning signal sounds
when the interior gets too warm. The
temperature display will also flash.
The audible warning device is turned
off by pressing the Alarm button. The
temperature display will continue to
flash until the cause of the alarm has
been rectified.
Figure 8