Filter
Top Products
15
GB
* Depending on model and options
Operation and control elements
Switchingtheapplianceonando
W Switching on: Press the on/o button
3so that the tem-
perature display lights up/ashes.
-
When the appliance is switched on for the rst time and
while it is still warm, the display will contain dashes until
the temperature falls below 0°C.
- The lighting will light up when the door is open.
W
Switchingo: Press the on/o button for approx. two
seconds so that the temperature display goes out.
Setting the temperature
The appliance is pre-set for normal operation. We recommend
a temperature of -18°C.
W
To reduce the temperature:
Press the DOWN button
2.
W To increase the temperature:
Press the UP button
2.
- While you are entering the temperature, the set tempera-
turewillash on the display.
- When you press the temperature setting buttons for the
rst time, the most recent setting (known as the "refer-
ence setting") is displayed.
-
You can change the settings in increments of 1°C by briey
pressing the buttons again. If the buttons are held down
the temperature setting will change faster.
-
The electronic controls will switch over automatically about
5 seconds after the last time you pressed the button, and
the actual temperature in the freezer (known as the "ac-
tual setting") will be displayed.
-
The temperature can be set at between -14°C and -28°C.
Whether you can obtain the lowest temperature depends
on where the appliance is positioned (if it is located in an
area with a high ambient temperature it will not reach the
lowest temperature).
Temperature display
The highest temperature of the frozen food 1 is dis-
played in normal operating mode.
The
displaywillash:
- if you change the temperature or
-
if the temperature rises by several degrees, indicating cold
loss, e.g. if you place fresh, "warm" food in the freezer or
if you remove or re-pack frozen food the temperature may
rise for a short time due to warm air owing into the freezer.
Once you have nished loading or re-packing, the electron-
ics will automatically re-set the temperature to the most
recent setting. Short-term rises in temperature will not
aect the frozen food.
W
If "
F 1" to "F 5" appears in the display, the appliance has a
fault. Consult the customer serv ice department indicat-ing
the fault number displayed as this will tell the techni-cian
what kind of irregularity has occurred.
Audible warning signal
The audible warning signal helps to protect frozen food
and to save energy.
W The
audiblewarningdeviceisswitchedoby pressing
the audible warning button
5.
- It switches o automatically as soon as the temperature is
low enough or the door is closed.
Audible door alarm
-
This sounds when the door has been left open for longer
than about 60 seconds. The sound switch-o function is
active as long as the door is left open. The alarm auto
-
matically switches back to standby when the door is shut.
Audible/visual temperature alarm
- It always sounds if the freezer temperature is not low
enough (dependent on the temperature setting).
-
The temperaturedisplayashes at the same time.
This can be caused by:
-
warm, fresh food being placed in the freezer,
-
too much warm air from the outside entering when re-ar-
ranging or removing frozen food.
The temperature display will continue to ash until the cause
of the alarm has been rectied. It will then stop ashing and
light up continually. The audible warning signal is now auto-
matically reset.
Power failure/FrostControl display
If appears in the display, this means that the freez-
er temperature has risen too high during the last few
hours or days due to a power failure.
W
If you press the audible warning on/o button
5 whilst the
display is reading
, the highest temperature regis-tered
during the power failure will be displayed.
-
Check the quality of the food and its suitability for con-
sumption in case it has become too warm or even de-
frosted.
- The highest temperature will appear for approx. 1 minute.
After that, the actual temperature in the freezer will re-ap-
pear. The display can be switched o by press
ing the
audible warning on/o button.
Once the power is re-instated, the appliance will continue to
operate at the most recent temperature setting.
Additional functions
In set-up mode you can set the child-proof lock and adjust
the brightness of the display*:
Activating set-up mode:
W Press SuperFrost button for approx. 5 secs - the Super-
Frost button ashes - the display shows
c for child-proof
lock.
Note: the value to be altered ashes.
W Select the required function by pressing the Up/Down but-
ton:
c = child-proof lock or h = brightness.
W Now select/acknowledge function by pressing SuperFrost
button briey:
• For c = child-proof lock, press the Up/Down button to
select c1 = child-proof lock on or
c0 = child-proof lock oand acknowledge with
the SuperFrost button. When the symbol
6 is lit,
the child-proof lock is activated.
• For h = brightness, press Up/Down button to
select h1= minimum to h5 = maximum brightness and
acknowledge with the SuperFrost button.
Exit set-up mode:
W To exit the set-up mode, press the On/O button;
after 2 mins. the electronic system switches over
automatically.
- The normal operating mode is activated again.
1
7
4
A1
DF
DuraFreeze
6
3
5
2
GNP..06