Filter
Top Products
Malfunctions
If a malfunction occurs during operation, check whether it is due
to an operating error.
You may be able to rectify the following faults yourself:
Appliance does not function:•
- Is the appliance switched on?
- Is the plug correctly fitted in the mains socket?
- Is the fuse intact?
Loud running noise:•
- Is the appliance set up firmly on the floor?
- Does the appliance cause nearby items of furniture or objects
to vibrate? Please note that noises caused by the refrigerant
circuit cannot be avoided.
The temperature is not low enough:•
- Is the temperature setting correct (see "Setting the tempe-
rature")?
- Have excessive amounts of fresh food been placed in the
appliance?
- Does the separately installed thermometer show the correct
reading?
- Is the ventilation system working properly?
- Is the appliance set up too close to a heat source?
If none of the above causes apply
and you cannot rectify the fault your-
self, contact the nearest customer
service department stating the type
designation , service number
and appliance number as indi-
cated on the type plate.
The position of the type plate is
shown in the section entitled Des-
cription of the appliance.
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch
off the socket and pull out the mains plug.
Clean the appliance and leave the door open in order to prevent
unpleasant smells.
The appliance complies with the relevant safety regulations and
EC Directives 2004/108/EC and 2006/95/EC.
Cleaning
Clean the appliance at least twice per year.
Before cleaning always switch off the appliance. Pull out
the mains plug or switch off.
Clean the inside, equipment and outer walls with lukewarm •
water and a little detergent. Do not use abrasive or acid
cleaners or chemical solvents.
Ensure that no cleaning water penetrates into the electrical •
components or ventilation grille.
The dust should be removed from the refrigeration unit and •
heat exchanger - metal grid at the back of the appliance -
once a year.
Do not damage or remove the type plate on the inside of the •
appliance. It is very important for servicing purposes.
Do not use steam cleaners because of the
risk of injury and damage.
Interior light
Display light
LED lighting is used for interior and display.
The interior light together with the display •
light can be turned on and off using the
button
Press button more than 1
sec
Important
The lighting may only be replaced by the
customer service technician or by competent skilled per-
sonnel!
Caution - class 1M laser radiation. When cover is removed,
do not look directly at light through optical instruments.
GBGB