Liebherr HCS 7081411-00 Refrigerator User Manual


 
20
ICEMAKER
Safety Instructions and
Warnings
The ice maker is designed exclusively to make
ice cubes in quantities needed by a household
and may only be operated with water appropri-
ate for this purpose.
All repairs and work on the ice maker may only
be done by customer service personnel or other
appropriately trained personnel.
Do not consume or use the first three
batches of ice. This applies both to using the
appliance for the first time and also using it
after it has not been used for a long period of
time.
The manufacturer cannot accept liability for
damage caused by equipment or water lines
between the solenoid valve and the water
supply.
The ice maker will only work if the combined
refrigerator-freezer is connected to the electrical
outlet. It will only make ice cubes if the freezer
compartment is operating.
The ice maker can only make ice cubes if the
upper freezer drawer is completely closed and
the ice cube bin is installed correctly (Figure 20).
To Start the Ice Maker
To turn the Ice Maker on
Touch the Ice Maker icon so the Ice Maker
LED comes on (Figure 23).
After you start the ice maker for the first time it may
take up to 24 hours before the first ice cubes are
ready.
Note
The first three batches of ice must not be
consumed or used.
The production capacity depends on the tempera-
ture inside the freezer compartment. The lower the
temperature, the more ice can be produced over a
period of time.
The ice cubes fall out of the ice maker into the Ice
cube bin (Figure 20). When the ice reaches a cer-
tain level in the bin, the appliance stops producing
ice automatically.
To turn the Ice Maker off
If you do not need any ice cubes, the ice maker
can be turned off independently of the freezer com-
partment.
Touch the Ice Maker icon so the Ice Maker LED
goes out.
Note
The ice maker can also be turned on and off
by pressing the “ON/OFF” button at the ice
maker housing for approximately 1 second
(Figure 21).
Ice maker
Ice cube bin
Figure 20
Figure 21