Filter
Top Products
20
fig. G
fig. K
8. Dismantle the lower attachment bracket from the refrigerator
door. Align the bracket to the lines on the refrigerator door
panel. (fig. G).
Fasten the bracket with any hole wherever possible using a
minimum of 6 screws 4 x 16 mm.
fig. H
9. Open the refrigerator door and suspend the refrigerator panel
on the top adjusting pins (fig. H).
10. Screw securing nuts onto the adjusting pins and slightly tighten
(fig. H).
11. Move the panel to the left until it makes contact with the center
rail (fig. I).
12. Tighten the hex nuts finally.
fig. I
13. Fasten the refrigerator panel using the same screws that
held the lower bracket before removal (fig. K).
14. Extend the soft-stop cylinder and connect with the ball stud
(fig. L).
fig. L
15. Attach the retaining clamp to the ball housing of the soft-stop
cylinder (fig. M).
fig. M