Filter
Top Products
4
IMPORTANT SAFETY INSTRUCTIONS
WARNING
To reduce the risk of fire, electrical shock,
or injury when using your Beer Dispenser,
follow these basic precautions:
• Read all instructions before using the unit.
• DANGER or WARNING: Risk of child entrapment.
• To avoid the possibility of child entrapment, please take the following precautions
before throwing out the appliance.
- Remove all doors from the unit.
- Leave the shelves in place so that children may not easily climb inside.
• Before you throw away your old unit: Take off the doors. Leave the shelves in
place so that children may not easily climb inside.
• Never allow children to operate, play with, or crawl inside the unit.
• Refrigerants: All refrigeration products contain refrigerants, which under the
guidelines of federal law must be removed before disposal of product. It is the
consumer’s responsibility to comply with federal and local regulations when
disposing of this product.
• Never clean unit parts with flammable fluids. The fumes can create a fire hazard or
explosion.
• Do not store or use gasoline or any other flammable vapors and liquids in the vicinity
of this or any other unit. The fumes can create a fire hazard or explosion.
-Save these instructions-
INSTALLATION INSTRUCTIONS
Before Using Your Beer Dispenser
• Remove the exterior and interior packing.
• Check to be sure you have all of the following parts:
• Instruction manual
• 1 Safety Guard Rail
• 1 Drip Tray (2 Pieces)
• 1 CO
2
Cylinder Support
• 1 CO
2
Regulator (Box)
• 1 CO
2
Empty Cylinder(Box)
• 1 CO
2
Air Line Hose (Red)
• 1 Beer Keg Coupler (Box)
• 1 Beer Tower
• 1 Pull Handle (Beer Tower Faucet)
• 1 metal wrench
• 4 Plugs: For Guard Rail Holes
• 1 Metal Plate For Cabinet Bottom
• 2 Steel wire shelves
• 1 Steel Clamp for Red Hose
• 4 Castors with lock
• Before connecting the Beer Dispenser to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system
from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Installation of Your Beer Dispenser
• This appliance is designed to be free standing only, and should not be recessed or built-in.
• Place your Beer Dispenser on a floor that is strong enough to support the Beer Dispenser
when it is fully loaded.
• Allow 3 inches of space between the back and sides of the Beer Dispenser, which allows the
proper air circulation to cool the compressor.
• Locate the Beer Dispenser away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase