Filter
Top Products
8
OPERATING INSTRUCTIONS
Assembling
NOTE: Always place the unit on a firm, level, and secure place. The air passage at the bottom
and the side of the motor housing should be kept free and clear.
1. Press the fasten button and hold the
head to insert it into the inlet; the
head must be slanted.
2. Then, rotate the feeder head counter-
clockwise so that the head is secured
tightly.
3. Place the feed screw into the head
with long end first; turn slightly to
feed the screw until it is set into the
housing.
4. Place the cutting blade onto the feed
screw with the blade facing the front.
Unless the blade is fitted properly, the
meat and/or food will not grind.
5. Place the desired cutting plate on top
of the blade.
6. Support the center of the cutting plate
with a finger while securely screwing
the screw ring. Do not over tighten.
7. Place the hopper plate securely on the
head.