Filter
Top Products
The temperature range of the wine cooler is intended
.
The temperature range of the beverage cooler i
s
for 43°F to 64°F (+/- 5°F ). intended for 41°F to 54°F (+/- 5°F ).
A
verage temperature for red wine is 54°F to 61°F.
.
A
verage temperature for white wine is 43°F to 50°F.
PRESET WINE ZONES: NORMAL' pad is pressed, the appliance runs on the
Press the [Red] or [White] pads to choose prese
t
'NORMAL' setting of 45°F and the 'NORMAL' indicato
r
storage conditions for Red or White Wine. (The lights.
indicator 'RED' or 'WHITE' will light accordingly.) The MANUAL TEMPERATURE SETTING:
programmed Temperature for red or white wine will The temperature of the beverage cooler can be set
be displayed for a few seconds. anywhere between 41°F to 54°F by the temperature
up ▲ and temperature down ▼pads as follows:
(1) Press the [SET] pad until you hear a "beep"
(approxima
t
(2) Press the ▲▼ pads to increase or decrease
the desired temperature in increments of one degree.
(3) Press the [SET] pad to confirm your choice - if
confirmation is not made within ten seconds the unit
will go back to the previous setting.
(3) Press the [SET] pad to confirm your choice - if NOTE:
confirmation is not made within ten seconds the unit
.
The 'MANUAL' indicator lights when the appliance
will go back to the previous setting. runs on 'MANUAL' setting.
NOTE:
.
The temperature display can be changed between
The temperature display can be changed between Celsius and Fahrenheit by pressing and holding
Celsius and Fahrenheit by pressing and holding
the ▲ pad for approximately 10 seconds.
the ▲ pad for approximately 10 seconds.
The following is applicable to both MCWC50DBT and MCBC580DBT:
To return the controller back to the Factory Setting,
press and hold the ▼ pad, within one second press ▲
pad and continue holding both for approximately 10 seconds, until you hear a "beep" sound signaling that th
e
To switch the interior light on/off, simply press the pad.
5
starts; (2) It remains ON during the refrigeration cycle; (3) It remains OFF during the idle cycle.
Temperature Control and Display
MANUAL TEMPERATURE SETTING:
(2) Press the ▲▼ pads to increase or decrease
The display usually shows the average temperature
anywhere between 43°F to 64°F by the temperature
The temperature of the wine cooler can be set
(1) Press the [SET] pad until you hear a "beep"
The display usually shows the average temperature
Wine Cooler MCWC50DBT
of the appliance at that moment.
Beverage Cooler MCBC580DBT
The indicator indicates status of the refrigeration cycle as follows: (1) It flashes before the compressor
the desired temperature in increments of one degree.
of the appliance at that moment.
sound (approximately fifteen seconds).
controller is back to the original Factory Setting.
NORMAL TEMPERATURE SETTING:
Whenever the appliance is switched on, or the
up ▲ and temperature down ▼pads as follows: