Filter
Top Products
1. Pull out the power plug from wall socked.
Use a screw driver to loose the screw that holds
the bulb protective cover and then remove the
cover.
2. Screw out the old bulb counter-clockwise.
3. Screw on a new bulb (E14, max. 15W)
clockwise.
4. Replace the bulb protective cover.
situated above the compressor, from where it Very important: Be sure to disconnect power
evaporates. supply before you change bulb.
If you do not intend to use the appliance for long
periods of time, disconnect the power supply,
Correct Steps to Change Bulb
Switch Off the Appliance
When Not In Use
take out the contents and defrost and clean the
There is no need to defrost the appliance,
because ice depositing on the inner back wall is
agents as you may damage the surface.
the appliance.
Disconnect the power supply before cleaning
Ice build-up on the inner back wall during the
Cleaning the Appliance
defrosted automatically.
After cleaning, connect the appliance to power
Maintenance and Cleaning
Automatic Defrosting of the
Appliance
6
compressor operation will defrost automatically
(when the compressor has cycled off) . Defrost
water will drain out passing through the drain
outlet in the inner back wall into a drain pan
interior of the appliance and clean with water and
liquid detergent. Plastic parts cannot be washed
appliance. Leave the door slightly open.
This unit is not designed for
outside installations such as
garage or porch.
supply and reload it.
Do not use coarse or aggressive cleaning
Clean the exterior with water and detergent.
Remove the detachable accessories in the
in dishwashers.
water , adding one or two spoonfuls of vinegar.
Wash the interior of the appliance with lukewarm