Filter
Top Products
Installation
MKG Series Gas Griddle
L25-052 Rev. 0 (5/06)
6
1.5.1. Counter Use With Legs
CAUTION
To prevent equipment damage, DO NOT
tilt your MagiKitch'n griddle on only two
legs, or on its sides.
(See Figure 2) A set of 4” legs is shipped
with the appliance (unless appliance was
specifically ordered without legs). A
threaded receptacle is located near each
corner of the underside of the base of the
appliance, on appliances 48" and wider
there are threaded receptacles in the front
and rear center of the base. Each leg has a
similar mating thread. Raise appliance
sufficiently to allow legs to be screwed tightly
into receptacles. The appliance can be
leveled by adjusting the feet at the bottom of
the leg assembly. This can be done by
turning the foot in or out to lower or raise
each corner as needed.
NOTICE
4" Legs should not to be used with the optional
Equipment Stand.
1.5.2. Counter Use Without Legs
(See Figure 3) The appliance must be sealed to
the counter to comply with applicable sanitation
standards. A bead of silicone sealant,
approximately ½ inch wide, is to be applied to
the bottom of the unit approximately ¼” in from
the front, back and side edges. We suggest Dow
Corning ®, GE ® or Permatex ® silicone ‘RTV’
adhesive sealant or equivalent. (See NSF Basic
Criteria C-2 for details).
1.5.3. For Use On Optional
Equipment Stand
ATTENTION
Rear mounting brackets should be installed
to the Equipment Stand prior to placing
griddle on the stand.
CAUTION
Only two of the four supplied casters are
equipped with a locking feature. Install the
griddle so that the two locking casters are at
the front of the unit. The casters should be
LOCKED before the unit is placed into
operation.
(See Figure 4). To mount the griddle to the
stand, locate joining kit supplied with stand. The
joining kit should include (2) rear mounting
brackets, and (4) 1/2" mounting bolts. To mount
the griddle to the equipment perform the steps
on the following page:
Figure 2
CAUTION
The appliance must be level to perform properly.
Failure to level unit may result in improper
combustion and performance of the appliance.
Figure 3
LIQUID TIGHT SEAL
ALL FOUR SIDES
SIMULATED BASE