Filter
Top Products
Figure 3
Figure 2
Figure 1
Figure 4
-10-
IMPORTANT: Your Blending Jars, Shaving and Blending Blades
are subject to wear during normal use. Always inspect
for nicks, chips, or cracks. Always carefully inspect
for broken, cracked, or loose blades. If any of the Jar
or Shaving and Blending Blades are damaged, do
not use. Call our toll-free customer service number,
1-877-689-2737, to obtain replacement parts.
1. Make sure unit is unplugged. Place on a clean dry
surface. Turn the unit so the back is facing you.
Remove the Ice Reservoir Lid by turning clockwise to the
unlock position (Figure 1).
2. To remove the Ice Reservoir, push down on the
Ice Reservoir Release Button (Figure 2). Lift the back of the
Ice Reservoir and remove. This will expose the Hopper Cover,
Shaving Paddle and Ice Hopper.
NOTE: THE SHAVING BLADE IS LOCATED INSIDE THE ICE
HOPPER (FIGURE 3).
WARNING: SHAVING BLADES ARE SHARP. DO NOT
PLACE FINGERS INSIDE THE ICE HOPPER
NEAR THE SHAVING BLADE. BLADE IS SHARP;
HANDLE WITH CAUTION.
3. To remove the hopper cover, simply lift up at either cut out
area in front of the ice hopper release catches. (Figure 4)
4. To remove the Shaving Paddle, unscrew the Shaving
Paddle Thumb Screw counter-clockwise until loosened
(Do not separate from shaving paddle), then remove the
Shaving Paddle by lifting straight up (Figure 4), exposing
the Ice Hopper and Shaving Blade. To reassemble, place
the Shaving Paddle back into position, and screw down the
Shaving Paddle Thumb Screw clockwise until tightened
properly. (Figure 5).
NOTE: THE ICE PADDLE IS KEYED TO MATCH THE SHAFT.
MAKE SURE TO ALIGN PROPERLY TO ASSEMBLE.
NOTE: IF THE ICE PADDLE THUMBSCREW IS TOO TIGHT USE
THE BOTTOM OF MEASURING CUP TO LOOSEN .
5. Press the two Ice Hopper release catches and lift
the Ice Hopper to remove (Figure 6).
PLEASE FOLLOW THE INSTRUCTIONS BELOW TO
SAFELY REMOVE THE SHAVING BLADE ASSEMBLY
FROM THE ICE HOPPER.
Cleaning and
Maintenance