Filter
Top Products
How to Clean and
Maintain Your Wine Chiller
Condenser: The condenser tubing inside the cabinet
does not require frequent cleaning; however, satis-
factory cooling depends on adequate ventilation over
the coils. Be sure that nothing obstructs the required
air flow openings in front of the cabinet. At least once
or twice a year brush or vacuum lint and dirt from the
condenser for efficient performance by unscrewing
the grille on the bottom front of the cabinet.
Cabinet: The painted cabinet can be washed with
mild soap and water and thoroughly rinsed with clear
water. Never use abrasive scouring powders.
Interior: Wash interior compartment with mild soap
and water. Do not use an abrasive powder, solvent,
polish cleaner or undiluted detergent.
Glass Door: Use a glass cleaner or mild soap and
water and soft cloth to clean the glass door model.
Do not use any abrasive powders.
Door Gasket: The vinyl gasket may be cleaned with
mild soap and water, a baking soda solution or a mild
scouring powder.
Light Tube Replacement: WARNING! DISCONNECT
THE POWER CORD BEFORE ATTEMPTING LIGHT
TUBE REPLACEMENT. Failure to do so may result in
an electrical shock that could severely injure you.
This product uses two, 6 watt light tubes to illuminate
the interior of the wine chiller. The light tubes are very
reliable electrical components, but should either or
both light tubes not function properly, please call the
dealer you purchased your wine chiller from for
replacement light tubes. Use only original equipment
light tubes from your dealer or manufacturer.
Light tube replacement consists of using a small
phillips head screwdriver to remove the two screws
that hold a cover plate over the back section of the
light tube. Set the screws and cover plate aside for
re-assembly later.
Using a small flat-blade screwdriver, gently lever the
front section of the light tube down to allow it to be
pulled clear of the light housing.
Disconnect the two insulated electrical connectors
from the cabinet’s electrical cable and discard the old
light tube. Reconnect the insulated electrical connec-
tor of the new light tube to the cabinet’s electrical
cable connectors. Make sure they are secure and
fully inserted.
Carefully realign the light tube’s electrical terminals
back into the rear of the light enclosure channel mak-
ing sure not to crimp them. Gently insert the light tube
along the length of the light enclosure channel. Press
the light tube gently into the light enclosure channel.
Only a small part of the light tube should project
below the ceiling of the wine chiller. DO NOT USE A
HAMMER TO FIT THE LIGHT TUBE.
Place the light tube terminal cover plate back in its
original position on the light enclosure’s flange. Re-
use the original two screws to secure it in place. Plug
the wine chiller into the electrical socket. Check to
see if the light tubes operate properly. Your light
tube’s replacement is complete.
The light tubes are not covered by your guarantee.
Replacement tubes can be obtained from your serv-
ice provider or from Marvel Industries.
What to do in
the Event of a Power Failure
Most power failures are corrected within two hours
and will not affect the unit’s temperature providing you
minimize the number of door openings while the
power is off. A gradual rise in temperature should not
have any adverse effect on your wine if power is out
for a longer period. If it is extremely hot, you may
want to move your wines to the coolest location you
can find until power is restored.
3