Filter
Top Products
8
CONDENSATE PAN INSTALLATION FOR TOP MOUNT CABINETS ONLY
1. Before moving cabinet into place,
remove the condensate pan from the
top unit compartment.
2. Using the two screws supplied with
the pan, attach the pan to the back of
the cabinet at the two holes near the
bottom of the plastic drain line. Be
sure pan is NOT located directly
under cabinet. When the pan is
attached, feed drain line into the
open hole in screen and clamp the
heater conduit to the back of the
cabinet. Due to this condensate pan,
this case must be a minimum of 6”
from the wall.
3. If cabinet must be located next to
wall on legs, the pan can be located
under the cabinet. When this is done,
steam will accumulate on the bottom
of the cabinet if there is not adequate
ventilation, and rusting of the bottom
of the cabinet will occur.
4.
Low Temperature Freezers – TAF Models
The TAF - 27 models are cord connected and operate on a 15 amp, 115/60/1 circuit. The TAF – 48 and TAF-
74 models have two junction boxes mounted on top of the cabinet, at the right rear, for permanent connection
to power. One junction box is labeled 115v. (black, white and green lead) ; the other is labeled 230v. (black, red
and green lead). These boxes should be connected to their respective power source. Check inside the cabinet
for the power requirement for each cabinet. The label is located in the upper left hand corner.
ERC 2 – ELECTRONIC REFRIGERATION CONTROL
Programming
The ERC 2 control initially powers up displaying 12:00 AM otherwise it will show the last configured
selection (time or temperature). If a power outage occurs during normal operation, the control will
maintain the correct time-of-day using a capacitor (batteries are not required). The time will be
maintained for up to 100 hours when the capacitor is fully charged.
To access the pushbuttons on the ERC2,
flip up the front cover using the tabs on
the side of the cover as shown.