Filter
Top Products
Hardware:
Tools needed:
Assembly Step 5
Locate these parts:
Phillips Head
Screwdriver
3/8”
Wrench
1. Turn the smoker upright.
2. Set the damper plate on top of the cabinet and line
it up with the corresponding “butterfly” holes. One
of the tabs will seat inside one of the holes.
3. Insert a bolt from the top through the
center hole.
4. From the bottom side, place
a lock washer and nut
on the bolt as shown.
5. Thread the nut just
tight enough to keep
the damper plate
snug. It should be
able to rotate with
little resistance.
10
10-24 Lock Washer
1 Required
10-24 Nut
1 Required
10-24 x 5/8” Bolt
1 Required
HARDWARE BAG
C
Damper
Bolt
Lock Washer
Nut
Cabinet Panel
Damper
Plate