Filter
Top Products
18
LP Tank
Not Included
Cylinders must be filled before initial use. All handling, transport, filling and storage of LP gas cylinders must be in
accordance with
Cylinders must be suitably tied down during transport. Do not place any other items on top of cylinders at
any time. Cylinders are not to be exposed to excessive temperatures or high heat.
Gas Tank outlet must have Type 1 gas connection termination in order to mate with gas hose provided with smoker.
The pressure regulator and hose assembly supplied by the manufacturer with the appliance must be used. Replacement
pressure regulators and hose assemblies must be those specified by the appliance manufacturer.
The regulator/hose assembly should be handled carefully to prevent contamination by foreign objects and dirt. The assembly
should be inspected before use and any dirt or contamination should be wiped off. In order to insure proper operation, any
replacement of the fuel tank regulator assembly has to be done with parts authorized by the smoker manufacturer.
This unit is not to be utilized with a non-self-contained LP-gas supply system
After all connections are completed, check all connections and fittings for leaks with a soap solution.
- With all valves closed, apply the leak check solution (50/50 mix of dishwashing detergent and water) to all gas carrying
connections and fittings.
- Open tank valve.
Presence of bubbles at areas of wet solution indicates a gas leak.
If leaks are detected or you smell or hear gas, shut off the valve
and repair the leak or replace the defective part. Do not use the
smoker until all leaks are corrected.
When setting up the smoker and tank, it is recommended to have
the tank and smoker on a line perpendicular to the wind direction.
The gas hose/regulator assembly should be totally extended
to the maximum distance so that the hose is straight and the tank
is as far from the smoker as it can be.
LP tanks are intended for operation in the upright position only.
Care should be taken to protect the fuel supply hose from damage
from either foot or vehicle traffic.
If the appliance is not in use, the gas must be turned off at the supply
cylinder and the cylinder should be disconnected from the appliance.
Storage of the appliance indoors is only permissible if the cylinder
is disconnected and removed from the appliance.
NFPA 58 Storage and Handling of Liquid Petroleum Gases, or CSAB 149.1 Natural Gas and Propane
Installation Code.
If there is a question on the identity of your unit and of the type of fuel to be used, please look on the data plate.
Units are factory equipped for use on only one type of fuel. These units cannot be, and should not be used on other
type of fuels. Doing so can cause severe damage to the unit and the installation area and the added risk of serious
injury. Any attempt to operate these smokers on fuels for which they are not design certified voids the
manufacturer's warranty.
Valve/pressure regulators are factory set to the correct operating pressures. No attempts should be made to
adjust these settings!
Connecting the LP Tank - Continued
Checking for Leaks
ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE
FOLLOWED TO PREVENT FIRE, DAMAGE, AND / OR INJURY.