Filter
Top Products
• This appliance is equipped with an overheat
safety feature.
• If appliance overheats it will shut off
automatically.
• To reset appliance, unplug from outlet, then
insert a tooth pick into small hole found on
control panel as shown.
RESET FUNCTION
BASKET
WATER
ELEMENT
Add water until it reaches bottom of the basket.
Do not allow water to evaporate so that element
is exposed. This will cause the element to
overheat and may damage the unit.
HOW TO
STEAM USING APPLIANCE
Masterbuilt recommends cleaning unit prior to and after use.
Clean lid, inner pot, and basket with a damp cloth or sponge using a mild detergent.
Rinse and dry thoroughly. These parts may also be cleaned in a dishwasher.
Clean outer shell, cord, control panel and element with a damp cloth or sponge using
a mild detergent. Dry thoroughly. NEVER put these parts in a dishwasher.
Periodically check mounting screws on handles and feet to make sure they are still
secure. Tighten as needed.
CAUTION: Over-tightening can result in stripping of screws or cracking of handles
or feet.
Turn appliance off, unplug and let cool
for 2 hours if using water, 5 hours if
using oil before cleaning or storing.
CAUTION: Do not pour used oil in
sink. Drain it back into oil containers.
DANGER:
Disconnect electric cord from
outlet, before cleaning, servicing and/or
removing heating element. Electrical shock
can result in personal injury or death.
CLEANING, MAINTENANCE & STORAGE
WARNING: Do not place control panel under running water.
Immersing control panel and cord can cause electrocution.
Step 1
Mount control panel & element onto bracket on outer shell.
Step 2
Plug power cord into an outlet (refer to “Warnings & Important Safeguards” section of
manual). Power light (red) will illuminate indicating unit is plugged in, element is
mounted correctly and unit is on.
S
tep 3
Turn control knob clockwise to desired temperature. Element will not begin heating until
knob goes past 100°F (38
°
C). Indicator light (green) will illuminate when temperature
has been reached.
S
tep 4
When cooking time has elapsed and food is done, turn knob counter-clockwise to “MIN”
and unplug power cord.
Allow excess oil to drain by hooking basket on side of pot with drain clip.
OPERATING INSTRUCTIONS
STARTER TIPS
FOR SAFETY, heating element only heats up when properly attached to the mounting
bracket (see assembly instructions). This is a powerful heating element and may
cause circuit breaker to trip. Minimize occurrences by operating any additional
appliances on a separate circuit. Tripping the circuit breaker will NOT damage unit or
household electrical system.
PRE-HEATING oil or water may take up to 55 minutes to reach cooking temperature.
Take advantage of this time to prepare foods for cooking. For optimum performance,
completely pre-heat unit to cooking temperature before frying or boiling foods.
Keeping lid ON during pre-heating and cooking cycles will reduce heating time and
keep temperature more consistent.
INDICATOR LIGHT (green) will turn OFF when heating liquid in unit. It will turn ON
when liquid has been heated to designated temperature. Indicator light may turn on
and off during cooking as heating element works to maintain a constant temperature.
WARNING: Place unit on level and stable surface to prevent tipping.
CAUTION: Do not mix different type oils at same time.
CAUTION: Never melt fat or lard on heating element or
in basket.
CAUTION: Hot when in use.
CAUTION: Do not fill past fill line in pot.
WARNING: Do not use appliance without water or oil in pot. It can be severely
damaged if heated while empty.
5 6