Filter
Top Products
Now start...
with oven in kitchen.
1
n Remove shipping materials, tape,
and protective film from oven. Do Not
remove shipping base at this time.
2
n Remove the racks and other parts
from inside the oven.
Personal Injury Hazard
l Use both hands to remove oven doors
l Grasp only the sides of oven doors.
l Do Not use handle or any portion of
the front frame or trim for lifting.
l Because of the weight and size of the
ovens, two or more people are
needed to move and safely install the
ovens.
Failure to properly grasp the oven doors
or to lift ovens properly could result in
damage to the product or personal
injury.
2
d n Completely open the lower oven
door. Remove the two oven door screws,
(Not all models have oven door screws,)
4
n Close lower or single oven door to
the broil position. Grasp the sides of the
oven door and pull the door up and out
of the hinge slots to remove. Set door
aside.
I
5
m Repeat Steps 3 and 4 for upper
oven.
Property Damage
Before moving ovens across floor,
check that ovens are on shipping
base or slide ovens onto cardboard or
hardboard.
Failure to follow these instructions may
result in damage to floor covering.
-
6
n Turn power supply off. Move oven
close to final position. Remove and
discard shipping base. Feed appliance
cable through the opening in cabinet.
Make electrical connection. See
“Electrical requirements” and “Electrical
connection” sections, Panel C.
Product Damage
Carefully push against the seal area
of the oven front frame when pushing
the oven into the cabinet.
Do Not push against outside edges.
Failure to follow these instructions can
result in damage to oven finish.
7
n Lift oven up into cabinet cutout
using the oven opening as an area to
grip.
Push against seal area of front frame to
push oven into cabinet.
4 screwS 4 screwS
8 8
H Center oven into cabinet cutout. H Center oven into cabinet cutout.
Use two screws (four screws for a double Use two screws (four screws for a double
oven) through the mounting holes in the oven) through the mounting holes in the
front frame of the oven to secure the front frame of the oven to secure the
oven to the cabinet. Do Not overtiahten oven to the cabinet. Do Not over-tighten
screws. screws.
Use one low-profile
screw in this position.
9
n Install the lower vent grille using the
three screws provided.
1.
Numbers
correspond
to steps.
Panel D